Morris MHR-20025 User manual

Oil filled radiator
Model: MHR-20025
INSTRUCTIONS FOR USE
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS

Safety
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE
USING THE APPLIANCE.
1. This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
2.Children of less than 3 years should be kept away unless continuously
supervised. Children aged from 3 years and less than 8 years shall only switch
on/off the appliance provided that it has been placed or installed in its intended
normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
3.CAUTION - Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and vulnerable
people are present.
4.If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
5. WARNING: In order to avoid overheating, do not cover the heater.
6.The heater must not be located immediately below a socket-outlet.
7.Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.
8.This heater is filled with a precise quantity of special oil. Repairs requiring
opening of the oil container are only to be made by the manufacturer or his
service agent. Contact service agent if there is an oil leak.
9. When scrapping the heater, follow the regulations concerning the disposal
of oil. Do not dispose of the heater in household waste and recycle the heater
where local facilities exist for electrical goods and oil.
10.Do not use the appliance for other than its intended use. For domestic
indoor use only.
11.Place the appliance on a flat, stable, heat-resistant surface. Operating the
product in any other position could cause a hazard.
12.There may be trace of odor during the first few minutes of initial use. This is
normal and will quickly disappear.
13.Do not attempt to repair, disassemble or modify the appliance. There are no
user-serviceable parts inside.
14.CAUTION –if using an extension lead please ensure you do not exceed the
maximum rated running wattage/load of the extension lead.
15. Disconnect from mains when not in use or when moving or cleaning.

16. The heater is hot when in use .To avoid burns, do not let bare skin touch
hot surface.
17. Do not insert or allow foreign objects to enter the ventilation or exhaust
openings as this may cause an electric shock , fire or damage to the appliance.
18. Do not cover the heater. A fire may occur if the heater is covered with or
touches flammable material, including curtains, drapes, bedding etc. when in
operation. KEEP THE HEATER AWAY FROM SUCH MATERIALS.
19.Do not recharge non-rechargeable batteries.
20.Do not dismantle, open or shred cells.
21.Do not expose cells to heat or fire. Avoid storage in direct sunlight.
22.Do not short-circuit a cell. Do not store cells or batteries haphazardly in a
box or drawer where they may short-circuit each other or be short-circuited by
other metal objects.
23.Do not remove a cell from its original packaging until required for use.
24.Do not subject cells to mechanical shock.
25.In the event of a cell leaking, do not allow the liquid to come in contact with
the skin or eyes. If contact has been made, wash the affected area with
copious amounts of water and seek medical advice.
26.Observe the plus (+) and minus (–) marks on the cell and equipment and
ensure correct use.
27. Do not use any cell which is not designed for use with the equipment.
28. Do not mix cells of different manufacture, capacity, size or type within a
device.
29.Cells usage by children should be supervised.
30.Seek medical advice immediately if a cell has been swallowed.
31.Always purchase the correct cell recommended by the device manufacturer
for the equipment.
32. Keep cells clean and dry.
33.Wipe the cell terminals with a clean dry cloth if they become dirty.
34.Retain the original product literature for future reference.
35.Use only the cell in the application for which it was intended.
36.When possible, remove the cell from the equipment when not in use.
WARNING: The thermostat of this heater is not equipped with a device to
control the room temperature with accuracy. It is recommended not to use this
heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cutout, this appliance must not be powered through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.

Assembly
Turn the radiator upside-down on a scratch-free and stable surface to prevent
damage to the paint finish or your floor surfacing.
-Turn the radiator upside-down
-Pull out the wheel bases to both outmost sides, see Fig 1.
Only operate the radiator in normal upright position with the wheel assemblies
attached to the bottom
Fig 1
Remote control
The remote control requires one 2025 - 3V cell (supplied).
Follow the +/- polarity indicated on the remote control.
The remote control must be pointed towards the remote sensor on the control
panel.
If the remote control does not operate as expected, replace the cell.
Controls
A.Rear handle and Remote
control storage slot
B.Heater body
C.Wheel base
D.Front handle
E.Control panel
F.On/off power switch
G.Cable storage
H.Wheel

Move the appliance using the integrated handle.
The remote control can be stored in the slot integrated into the appliance at the
rear cover if not used.
Turning On
Press the on/off power switch [F] to turn the appliance on. The product is now
in stand-by awaiting a mode to be selected via the buttons on the appliance or
the remote control.
The appliance emits a beep sound.
The light on ( ) will turn on.
The following settings can be performed using the touchpad or the remote
control.
Abeep sound is emitted at every key press.
Press the stand-by button [f] to exit the stand-by mode and begin selection of
the different modes. Heater will start working under low power ( ).
Heating power and Eco mode setting
Press the Power/Mode button(c), it will cycle from default Low power( )
Medium power ( ) High power ( ) Eco mode( ).
a. Thermostat button
b. ＋: Temperature & hours increase
button
c. Power/Mode button
d. Timer button
e. －: Temperature & hours decrease
button
f. Stand-by button
Remote control
Battery (2025 - 3V)