Moxa Technologies MGate 5109 User manual

Industrial Ethernet Gateways
1www.moxa.com
Overview
Modbus and DNP3 Protocol Traffic Monitor
Easy Configuration via Web Console
Variety of Maintenance Functions
MGate™ 5109 Series
1-port Modbus RTU/ASCII/TCP-to-DNP3 serial/TCP/UDP gateways
The MGate 5109 is an industrial Ethernet gateway for Modbus RTU/
ASCII/TCP and DNP3 serial/TCP/UDP protocol conversion. All models
are protected with a rugged metallic casing, are DIN-rail mountable,
and offer built-in serial isolation. The MGate 5109 supports transparent
mode for easily integrating Modbus TCP to Modbus RTU/ASCII
networks or DNP3 TCP/UDP to DNP3 serial networks. The MGate
The MGate 5109 series gateways support Modbus and DNP3
Protocol Traffic Monitor for easy troubleshooting, especially during
the installation stage. Communication issues could be caused by
incorrect software parameters, such as slave ID and register address,
5109 also support agent mode to exchange data between Modbus and
DNP3 networks or to act as a data concentrator for multiple Modbus
slaves or multiple DNP3 outstations. The rugged design is suitable
for industrial applications such as power, oil & gas, and water and
wastewater.
or incorrect command configuration. With Modbus/DNP3 Protocol
Traffic Monitor, you can check the captured data and easily identify the
root cause.
The MGate 5109 series gateway provides a web console and Telnet
console for remote maintenance. Encryption communication functions,
including HTTPS and SSH, are supported to provide better network
security. In addition, firmware log functions are provided to record
connection events and Modbus maintenance events. Users can review
log data remotely through the web console.
The MGate 5109 series comes with an illustrated Quick Setup guide
designed to make configuration easy. With Quick Setup, you can easily
access protocol conversion modes and finish the configuration in a
›Supports Modbus master/slave and DNP3 master/outstation
›Up to 31 Modbus serial slaves or DNP3 serial outstations
›Up to 32 Modbus TCP slaves or DNP3 TCP/UDP outstations
›Supports DNP 3.0 subset level 2
›DNP3 master mode supports up to 26600 points
›DNP3 master and outstation modes support time-synchronization
›Complete diagnosis information for maintenance
›Embedded Modbus and DNP3 serial traffic monitor
›Redundant dual DC power inputs and relay output
›microSD card for configuration backup and system log
›-40 to 75°C wide operating temperature models available
›Serial port with 2 kV built-in isolation protection
›Built-in Ethernet cascading for easy wiring
few steps. The MGate 5109 series also supports Auto Detection for
DNP3 serial outstations, allowing the MGate 5109 to automatically
acquire all outstation objects when configured as a DNP3 master.

Industrial Ethernet Gateways
2www.moxa.com
Specifications
Ethernet Interface
Protocols: Modbus TCP client/server, DNP 3.0 TCP/UDP master/
outstation
Number of Ports: 2 (1 IP, Ethernet cascade)
Speed: 10/100 Mbps, Auto MDI/MDIX
Connector: 8-pin RJ45
Magnetic Isolation Protection: 1.5 kV (built-in)
Serial Interface
Protocols: Modbus RTU/ASCII Master/Slave
Number of Ports: 1
Serial Standards: RS-232/422/485, software selectable
Connectors: DB9 male
RS-485 Data Direction Control: ADDC® (automatic data direction
control)
Pull High/Low Resistor for RS-485: 1 kΩ, 150 kΩ
Terminator for RS-485: 120 Ω
Isolation: 2 kV (built-in)
Serial Communication Parameters
Data Bits: 7, 8
Stop Bits: 1, 2
Parity: None, Even, Odd, Space, Mark
Flow Control: RTS/CTS, RTS Toggle (RS-232 only)
Baudrate: 50 bps to 921.6 kbps
Serial Signals
RS-232: TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND
RS-422: Tx+, Tx-, Rx+, Rx-, GND
RS-485-4w: Tx+, Tx-, Rx+, Rx-, GND
RS-485-2w: Data+, Data-, GND
Modbus
Functions Supported: 1, 2, 3, 4, 5, 6, 15, 16, 23
Max. No. of Commands: 100
Max. No. of Connections:
MGate as Modbus TCP Master: 32 slave connections
MGate as Modbus TCP slave: 16 master connections
DNP3
Max. No. of Connections:
• Transparent mode:
16 master connections or 32 outstation connections
• Agent mode:
MGate as DNP3 TCP/UDP master: 32 outstation connections
MGate as DNP3 TCP/UDP outstation: 1 master connection
DNP3 Internal Database:
• For each outstation:
Binary Inputs: 256 points
Analog Inputs: 64 points
Counters: 64 points
Binary Outputs: 256 points
Analog Outputs: 64 points
• When the MGate 5109 is congured as a DNP3 outstation
Binary Inputs: 8192 points
Counters: 2048 points
Binary Outputs: 8192 points
Analog Outputs: 2048 points
Binary Input Events: 100
Analog Input Events: 100
Counter Events: 100
Software
Configuration Options: Web Console, Serial Console Utility
Configuration: MXview, SNMP (v1, v2, v3), Private MIB
Physical Characteristics
Housing: Metal, IP30
Weight: 507 g (1.12 lb)
Dimensions: 36 x 105 x 140 mm (1.42 x 4.14 x 5.51 in)
Storage Card Slot: 1 microSD (SDHC) card slot supports up to 32 GB
Relay Alarm Circuit: 3-pin circuit with current carrying capacity of 2 A
@ 30 VDC
Environmental Limits
Operating Temperature:
Standard Models: 0 to 60°C (32 to 140°F)
Wide Temp. Models: -40 to 75°C (-40 to 167°F)
Storage Temperature: -40 to 85°C (-40 to 185°F)
Ambient Relative Humidity: 5 to 95% (non-condensing)
Vibration: IEC 60068-2-6, IEC 60068-2-64
Shock: IEC 60068-2-27
Drop: IEC 60068-2-32
Power Requirements
Input Voltage: 12 to 48 VDC
Input Current: 455 mA max., Class 2
Power Connector: Terminal block
Standards and Certifications
Safety: UL 508, EN 60950-1
Hazardous Location: Class 1 Division 2, ATEX, IECEx
EMC: EN 55022/24
EMI: CISPR 22, FCC Part 15B Class B
EMS:
IEC 61000-4-2 ESD: Contact: 8 kV; Air: 15 kV
IEC 61000-4-3 RS: 80 MHz to 1 GHz: 10 V/m
IEC 61000-4-4 EFT: Power: 4 kV; Signal: 2 kV
IEC 61000-4-5 Surge: Power: 2 kV; Signal: 2 kV
IEC 61000-4-6 CS: 150 kHz to 80 MHz: 10 V/m
IEC 61000-4-8 PFMF
MTBF (mean time between failures)
Time: 859,422 hrs
Standard: Telcordia SR332
Warranty
Warranty Period: 5 years
Details: See www.moxa.com/warranty

Industrial Ethernet Gateways
3© Moxa Inc. All rights reserved. Updated Jul. 27, 2016. Specications subject to change without notice. Please visit our website for the most up-to-date product information.
Ordering Information
Available Models
MGate 5109: 1-port Modbus-to-DNP3 gateway, 0 to 60°C operating temperature
MGate 5109-T: 1-port Modbus-to-DNP3 gateway, -40 to 75°C operating temperature
Optional Accessories (can be purchased separately)
DR-4524: 45W/2A DIN-rail 24 VDC power supply with universal 85 to 264 VAC input
DR-75-24: 75W/3.2A DIN-rail 24 VDC power supply with universal 85 to 264 VAC input
DR-120-24: 120W/5A DIN-rail 24 VDC power supply with 88 to 132 VAC/176 to 264 VAC input by switch
WK-36-02: Wall-mounting kit
Mini DB9F-to-TB: DB9-female-to-terminal-block adapter
Package Checklist
• 1 MGate 5109 gateway
• 1 serial cable: DBL-RJ45F9-150
• Documentation and software CD
• Quick installation guide (printed)
• Warranty card
Dimensions
Unit: mm (inch)
Top View Front View Side View Rear View
Dual power inputs
and relay output
microSD card
DIN rail
105.04 (4.14) 36 (1.42)
4.3 (0.17)
149.25 (5.88)
140 (5.51)
113.84 (4.48)
Reset to default
button
LED indicators
Ethernet
Serial console
RS-232/422/485
microSD