MSI LIQUID COOLING Series User manual

Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per MSI GeForce RTX 4090 Suprim
Liquid 24G o cerca il tuo prodotto tra le migliori offerte di Schede Grafiche

1
Copyright and Trademarks Notice
Copyright © Micro-Star Int’l Co., Ltd. All rights reserved. The MSI logo used is a registered
trademark of Micro-Star Int’l Co., Ltd. All other marks and names mentioned may be
trademarks of their respective owners. No warranty as to accuracy or completeness is
expressed or implied. MSI reserves the right to make changes to this document without prior
notice.
Cautions and Statements
DO NOT touch the cooling system since it may produce a certain heat
while processing tasks.
Do not force the GPU cooler against the fragile GPU to avoid damage to
the GPU.
European Union: Under the European Union ("EU") Directive on Waste
Electrical and Electronic Equipment, Directive 2002/96/EC, which
takes effect on August 13, 2005, products of "electrical and electronic
equipment" cannot be discarded as municipal waste anymore and
manufacturers of covered electronic equipment will be obligated to take
back such products at the end of their useful life.

2
SUPRIM LIQUID (Closed Loop) Installation
• Step 1
1. Turn off the power, and disconnect
the power cable. Open the case of
your computer.
2. Remove the expansion brackets
required to place your graphics card.
3. Place the card directly over the PCI
EXPRESS slot
• Step 2
• Step 3

3
• Step 4
4. Carefully insert the card into the PCI
EXPRESS slot until the card is fully
seated. You will likely hear a click
when it is locked in place.
Note: Inserting the graphics card
into a wrong slot or using incorrect
orientation may damage the card.
Refer to your motherboard manual for
further information if necessary.
5. Secure the card with a bracket screw.
• Step 6
• Step 5
6. Align the graphics card’s radiator
to the available ventilation holes
of the computer case. (the radiator
placement may vary per computer
case)
7. Secure the radiator to the computer
case with the supplied screws.Note:
Rotate the tubes to a proper position
for the following installation in the
case.
• Step 7

4
8. Connect the required 16-pin power
connector to the graphics card.
9. Close the case, re-connect the power
cable and turn on the PC.
• Step 8
• Step 9

MSI.COM SUPPORT SOCIAL MEDIA