Multay MONTPELLIER DINING MO-2875M-NNN User manual

Step By Step Assembly Instructions
PRE-ASSEMBLY PREPARATION
1. Please check the pack contents before attempting this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact
the retailer from whom you bought this product.
2. This product is VERY HEAVY, it should be assembled as near as possible to the
point of use. TAKE CARE WHEN LIFTING to avoid personal in jury and ( or )
damage to the product.
3. This product takes approximately 60 minutes to assemble with 3 people.
4. The fitting pack contain SMALL ITEM which should be
KEPT AWAY FROM YOUNG CHILDREN
5. Read this leaflet in full before commencing assembly.
6. You will require an Allen Key (provided) to assembly this product.
Page 1
MONTPELLIER DINING COLLECTION
160/180 Cm Large Extending Table ( Product Code MO / 2875M / NNN )
Thank you for buying our product

Panel and Fittings Identification
MONTPELLIER DINING COLLECTION
160/180 Cm Large Extending Table ( Product Code MO / 2875M / NNN )
Thank you for buying our product
Item Description Qty
A
B
C
D
E
1
2
1
1
8
Table Top
Pedestal
Extension Leaf
Allen Key
Bolt
F 8Washer
Page 2
Spring Clips (inside)
G
GSpring Clips 4
F
5 mm L : 5 Cm

- With the help of 3 assistants locate the pedestals onto the underside of the table top.
Align the legs as shown below ( i.e the single leg pointing inwards ), whilst ensuring
that the dowels align to the holes in the table top.
Step
1
- To extend table, firstly ensure that the spring clips on the underside of the table are
un-done and the table leaves are pulled apart to their maximum. Carefully lift the leaf
from inside the table top and then fold the skirts down as shown in diagram bellow.
Step
2
MONTPELLIER DINING COLLECTION
160/180 Cm Large Extending Table ( Product Code MO / 2875M / NNN )
Page 3

Step
3
MONTPELLIER DINING COLLECTION
160/180 Cm Large Extending Table ( Product Code MO / 2875M / NNN )
-To secure the pedestals, use the eight bolts with washers inserted up
through the pedestal pilot holes and into the inserts located in the
pedestal attachment plates. (Please refer to diagram below) Tighten all
eight bolts using Allen key provided. Secure the sliding table tops
together, using the spring clips on the underside of the table. Refer to
Step 1 and Step 4 for instructions on extending your table.
IMPORTANT NOTICE : PLEASE ENSURE THE BOLTS
ARE INSERTED AS SHOWN BELOW
Page 4
WasherWasher
ARE INSERTED AS SHOWN BELOW
Page 4
WasherWasher
Pedestal attachment plate
Inserts Inserts
Dowel
Bolt 5 mm Bolt 5 mm

Step
4
- Locate the extension leaf between the table leaves, noting the location pins as shown.
Fold down the skirts on the leaf as per the diagram below. Finally push the main leaves
back together ensuring that the pins locate into the holes. Secure all tops together,
using the spring clips on the underside of the table to remove the extension, simply
perform the procedure in reverse, storing the extension under the table top.
The assembly is now complete.
Skirts Being Pulled Into Position
MONTPELLIER DINING COLLECTION
160/180 Cm Large Extending Table ( Product Code MO / 2875M / NNN )
Page 5