Multistore EXC-750H2 User manual

EXC– 750H2
ASSEMBLY INSTRUCTION FOR EXC-750 H2
PARTS IDENTIFICATION LIST
2 x TOP GABLES
2 x BOTTOM
GABLES
2 x BACKING
BOARDS FOLD LINE
2 x FIXED SHELF
1 x SAFETY BRACKET
2 x 30mm FLANGES
1 x 30mm HANGING RAIL
1 x BOTTOM KICK
1 x CAM SHELF
NO MODEL DESCRIPTION QTY
1CONFIRMAT SCREWS 50mm x 5mm 14
2WHITE CAPS 14
3DOWELS 4
4BACKING NAILS 75
516mm WOOD SCREWS 2
NO MODEL DESCRIPTION QTY
6CAMS 4
7CAM PINS 4
816mm PAN HEAD SCREWS 1
925mm PAN HEAD SCREWS 1
10 “L” SAFETY BRACKET 1
1 x 717mm H MOULD
When aaching unit to wall put safety bracket in
middle of unit with 16mm pan head screw then
25mm pan head screw into wall.
For plasterboard without a stud it is recommended
to use a plug with screw (not provided).
TOP of UNIT

RAIL SUPPORT
BRACKETS
DOWELS FIXED SHELF KICK
TAKE YOUR GABLES AND LAY THEM OUT
FLAT, YOU SHOULD HAVE 2 X TOP &
2 X BOTTOM GABLES. USING A LITTLE
WOOD GLUE (NOT SUPPLIED) IN YOUR
PRE-DRILLED HOLES, INSERT YOUR
WOOD DOWELS INTO 2 OF THE HOLES
AND PUSH YOUR TOP INTO YOUR
BOTTOM GABLE.
NEXT STEP:
YOU WILL NEED TO RETRIEVE THE INFILL FROM PART 2, USING 30mm
8 GAUGE SCREWS PROVIDED, ATTACH THE INFILL TO THE UNDER-SIDE
OF THE CAM SHELF BEFORE PUTTING YOUR SHELF INTO PLACE.
ALIGN YOUR SHELVES AND KICK TO THE LEFT-HAND GABLE, SCREW THEM INTO PLACE ATTACH
YOUR RIGHT-HAND GABLE AND DO THE SAME.
FOLD OUT BOTH TOP AND BOTTOM BACKS, THEN SLIDE THE
H MOULD INTO BOTH BACKS TO JOIN THEM TOGETHER.
PROCEED TO NAIL THEM INTO POSITION MAKING SURE YOU
ARE SQUARE.
YOU WILL NEED 2 X 16mm WOOD
SCREWS FOR THE NEXT STEP.
TAP INTO POSITION YOUR FLANGES
INTO THE HOLES PROVIDED IF YOU
WISH YOU CAN SCREW IN 1 SCREW
INTO THE MIDDLE OF THE FLANGE
AND SLIDE ON YOUR HANGING RAIL.
NEXT:-YOUR PART 2 IS REQUIRED
YOU WILL NEED THE DRAWER
ASSEMBLY SHEET ON HOW TO
CREATE YOUR DRAWER.

WARRANTY
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entled to a
replacement of refund for major failure.
10 Year Warranty
• If the purchaser has a fault or defect with this product, the purchaser needs to contact Mulstore Industries
(Aust) directly on [phone] and state date of purchase, place of purchase and proof of purchase.
• Mulstore Industries (Aust) will replace any faulty or defect parts at no cost to the customer. A replacement
will be sent to you as soon as possible, or product can be exchanged at the store of purchase.
• This warranty is in addion to other rights and remedies of the customer under law.
Sincerely,
Mulstore Industries (Aust) Management