MUND CLIMA WZ 32 Operating manual

WZ 32
English
CL19782
AIR CONDITIONING WITHOUT OUTDOOR UNIT
BEFORE INSTALLING AND USING THIS AIR CONDITIONER,
PLEASE READ ALL INSTRUCTIONS CAREFULL
User and installation
manual

1
2
4
5
5
6
6
7
8
9
P0
3
10
12
11
1.5 LIST OF ACCESSORIES(P0)
1.FASTENING BRACKET
2.REMOTE CONTROL
3.REMOTE CONTROL HOLDER
4.DRAINAGE PIPE
5.EXTERNAL GRATING
6.PLASTIC SHEET AIR PIPE
7.KIT OF SCREWS
8.GRATING FIXING CORD
9.INSTRUCTION MANUAL
10.PAPER TEMPLATE FOR WALL DRILLING
(See page)
11.160mm RING
12.150mm RING

Air directional flap
Flap uscita aria
Filter grating
Griglia filtri
Power cord
Cavo alimentazione
DISPLAY
RED LED power supply is connected; LED ROSSO: connessione elettrica
GREEN LED compressor is on; LED VERDE: compressore in funzione
YELLOW LED timer is on; LED GIALLO: funzione timer inserita
BLUE LED nigth mode is on; LED BLU: funzione sleep inserita
P1
Fresh air system
Ricambio aria
Model 32
Model 25

2m
P3
2m
Outdoor Indoor
P4
spirit level

P5
3° INCLINATION
P13
Soft terminal
Hard terminal
A
A
B
B
System "A" is more common use , and the
discharge pipe go outside where there is
no problem to connect or to discharge it ,
this solution is OK for hot country and
normal cold temperature out side .

P6
Usually "B" hole is used in the installation
when the outside temperature is very low,
and in this way we prevent no ice in the
discharge water pipe . This solution is used
also to be more easy for the installer to
connect the internal drainage pipe when he
don't want to see the pipe from outside.
P20
- After drilling the holes, the plastic sheet supplied
with the air conditioner need to be fitted through
them.
- Measure the depth of the wall and cut supplied
plastic sheet.
- Roll the sheet and insert it into the hole, paying
attention to the joint line, which must be always
upper position. Remember that the sheet must
have the same inclination of the holes(min 3°).
- Insert the rings into the holes.
150mm ring 160mm ring

P7
P8
P10
P9

LIFT IT UP
HERE
P11
P12
LIFT IT UP
HERE Water
P14
Water cap

*
* Only for 32 model

* Only for 32 model

* Only for 32 model

Close position

LIFT IT UP
HERE
LIFT IT UP
HERE
P15
P16
P17
P19
P18

5.The temperature is not properly set/Check
it.
* Only for 32 model