1. Before the first start
SIM card installation
myPhone FUN 4 is a mo ile phone with Dual SIM technology, which allows you to use
two mo ile networks simultaneously. First slot supports SIM or microSIM adapter, while
the second slot microSIM cards only. To insert the SIM card properly proceed as follows:
•Turn off the phone, remove the ack cover (undermine it with fingernail using a
slot designed for this purpose. It is located in the lower right corner of the phone)
and remove the attery.
•Insert the SIM card into the slot according to the drawings underneath the seat.
Memory card installation
Use only memory cards compati le and approved y myPhone. Incompati le memory
cards may damage the device, the card itself and lead all data loss. Incompati ility of
memory card can e caused y incorrect card format (requires microSD format) or
unsupported card size (over 32GB). To properly insert a memory card proceed:
• Turn off the phone, remove the ack cover (undermine it with fingernail using a slot
designed for this purpose. It is located in the lower right corner of the phone) and remove
the attery.
• Insert the memory card into the slot according to the drawings underneath the seat.
Charging the battery
Before you turn on the phone for the first time the attery needs to e charged. Charge
the attery with charger included in the set. The capacity of attery is 1800 mAh. In case
of pro lems with attery - the device should e delivered to myPhone service center.
You should only use chargers and ca les approved y myPhone. Unauthorized chargers
or ca les can cause the attery explosion and damage your device. When the attery
ecomes low, low attery indicator appears on display. To continue using the device,
recharge the attery. When the attery is completely discharged the phone can`t e
turned on even when loading is in progress. To turn it on again the attery needs to e
loaded for few minutes.
To charge the attery:
1. Connect micro-B USB (trapeze) into the appropriate slot in myPhone CUBE LTE.
Improper connection of charger (USB ca le) can damage your phone or AC
adapter. Any damages caused y misuse are not covered y the warranty.
2. Connect the charger to an AC outlet. Once you start charging an animated charging
icon should appear on the phone screen.
The device may heat up while charging. This is normal and should not affect the
sta ility or performance.
3. When charging percentage on the display reaches 100, it will mean that the attery is
full and you should finish loading.
