myPhone Funky User manual

© 2014 myPhone. All rights reserved. myPhone Funky ENG
USER MANUAL

Tech specification:
•RAM Memory: 512 MB DDR2
•Dual Core ARM Cortex - A7 1.3GHz – proce or
•4” capacitive touch creen with 800 x 480 px re olution
(5:3 ratio)
•8GB internal memory
•1500mAh battery
•Frontal camera re olution: 0.3 Mpx
•Rear camera re olution: 5.0 Mpx
•input and output charger parameter :
-input: 100-240V AC, 50/60Hz, 150mA
-output: 5V DC, 1000mA
•Power the phone under tandard condition :
-5V DC, 500mA
•Smartphone` weight: 125g
SIM card inserting
myPhone CUBE is a mobile phone using
Dual SIM technology. Dual SIM allows you to use two mobile
netwo ks at the same time. To inse t the SIM ca d co ectly follow
the inst uctions:
•Tu n off the phone, emove the back cove (unde mining the
slot located in the ight co ne of the base of the phone with
you nail) and pull out the batte y.
•Inse t the SIM ca d into the slot following the pictu es f om
above and below the socket.
MICRO SIM ADAPTERS
Do not install hollow (with no ca d) mic o-SIM ca d adapte in you
sma tphone. This will cause a jam. Attempt to d aw jammed adapte
back f om the slot can cause mechanical damage of the phone. If
SIM ca d adapte deadlocks in the socket, you should contact an
autho ized myPhone se vice!
Memory card inserting
Use only memo y ca ds compatible and app oved by myPhone.

Incompatible memo y ca d may damage itself and the device and
emove sto ed data. Incompatibility of memo y ca d can be caused
by inco ect ca d fo mat (mic o SD fo mat is equi ed) o
unsuppo ted ca d size (ove 32GB). To inse t the memo y ca d
co ectly follow the di ections:
•Tu n off the phone and take off the back cove (unde mining
the slot located in the left co ne of the base of the phone with
you nail).
•The memo y ca d slot is located above the batte y on the ight.
Following the d awing inse t the memo y ca d into the slot.
Battery inserting
To inse t the batte y:
•Tu n the phone back cove up.
•Take off the back cove (unde mining the slot located in the
ight co ne of the base of the phone with you nail).
•Inse t the batte y (pay attention to the co ect o ientation of the
batte y contacts and phone contacts – these should be
adjacent to each othe ).
•Replace the back cove .
Battery charging
The batte y should be cha ged p io to the fi st tu ning on the
device. Cha ge the batte y with the kit cha ge . The device has a
batte y capacity of 1800mAh. In case of any p oblems with the
batte y - the device must be p ovided to myPhone se vice cente .
Use only cha ge s and cables app oved by myPhone. Using
unapp oved cha ge s o cables could cause an explosion o
damage the batte y in othe way.

Front view:

Rear view