NanoVibronix PainShield User manual

PAINSHIELD QUICK GUIDE
Please read the complete PainShield manual before using the device and
pay attention to important warnings.
Press the ON/OFF button on the device for about 2seconds until beeping sound is heard.
The device requires a few seconds to initialize and then displays the information screen.
When the device is in working or charging modes, it enters the screen saving mode.
To check the status press shortly on the ON/OFF button.
The device can be turned off at any time by pressing and holding the ON/OFF button for 2seconds.
For maximal effectiveness ensure that the
active element is in full contact with clean,
hairless and oil-free skin
For extended patch usage follow handling
instructions on the patch label
4
Before applying the patch,
the skin should be thoroughly
cleaned. Remove the protective
liner from the treatment patch,
and keep it for storing after use.
Attach the treatment patch to
the skin with the adhesive side
down over the area where the
pain is most intense.
Connect the patch to the device
cable using the contact snaps.
patch
Active
element
Contact
snaps
For online guidance, please see:
https://youtu.be/h5NHm6apQbs
23
1
patch
Small
Driver Large
www.nanovibronix.com

Working mode
(Active period)
Working mode
(Idle period)
Treatment patch is
disconnected or damaged
Battery is empty and
requires charging
Treatment cycle
number: C1- C6
0.4 W - Acoustic power
Battery level
Time of treatment in the
cycle: 0-30 min status
Each cycle has an active period
of 30 minutes followed by an
inactive (idle) period of 30
minutes. The PainShield
battery allows for six
treatment cycles and then
shuts down automatically.
Screensaver screens:
1. In Charging mode 2. In Working mode
Charging in progress
C1 0.4 W
29 min
C1 0 W
IDLE
PainShield
PAINSHIELD QUICK GUIDE
[PSIFU019 rev. 02]