National Public Seating CONDUCTOR'S STAND User manual

ASSEMBLY INSTRUCTIONS
CONDUCTOR'S STAND
1-800-261-4112Page 1 of 2 www.nationalpublicseating.com
CONDUCTOR'S STAND COMPONENTS
1x Desk
A
1x Tray
B
1x Base
E
2x Glide
F
1x Telescopic
Clamp Lock
C
1x Telescopic
Tube
D
TOOLS FOR ASSEMBLY
3.0 Allen
Wrench
1x
7
4.0 Allen
Wrench
1x
8
Small Open
End Wrench
1x
9
Large Open
End Wrench
2x
10
1Using the 3.0 Allen Wrench
loosen the base end M5x8 Bolts
so that the Base has some
clearance, then remove the M6x50
Bolts and M6 Lock Nuts
using 4.0 Allen Wrench and
Small Open End Wrench .
E
7
1
23
9
8
3
9
2
E
1
7
2
Ensure that all bolts are fastened tightly.
Install Conductor's Base to Telescopic Tube as follows: Begin by
Inserting the telescopic tube through the base. Align the two base holes
over two holes on telescopic tube. Insert two M6x50 Bolts and tighten
with two M6 Lock Nuts using 4.0 Allen Wrench and Small Open End
Wrench .
E D
2
3 8
9
E
D
8
2
8
4

Dear Customer, Thank you for your purchase. Although extreme care goes into manufacturing & packaging of
this product, mistakes are possible. If you encounter any missing parts or diculty in assembly, please contact
our customer service Toll Free at 1-800-261-4112 or [e-mail] for courteous & immediate
resolution to your problem.
1-800-261-4112Page 2 of 2 www.nationalpublicseating.com
4Remove the pre-installed M8 Hex
Head Bolt , M8 Lock Nut and
Dome Washers . Slide the Desk
. into position and secure the
previously removed hardware
tightly using two Large Open End
Wrenches .
A
4 5
6
10
A
4 5
6 6
5To install the tray , align holes
on the Tray Bracket with the
holes on the Inner Tube , to
secure the Tray in position use the
M6x40 screws provided
B
D1
B1
B
D1
B1
D1
11
6To adjust the height of the
Conductor's Stand, loosen the
Clamp Lock Knob and pull out
the Inner tube , then re-secure
the Telescopic Clamp Lock .
C
D
C
D
D
C
3Tighten the M5x8 Bolts on the
ends of the Base securely
using 3.0 Allen Wrench .Place
the Glides on the ends.
F
E
1
7
Ensure that all bolts are fastened
tightly.
1
7
F
E
Congratulations, your Conductor's Stand is now assembled and ready to be used!
11