National Public Seating TAD User manual

Dear Customer, Thank you for your purchase. Although extreme care goes into manufacturing & packaging of
this product, mistakes are possible. If you encounter any missing parts or diculty in assembly, please contact
our customer service Toll Free at 1-800-261-4112 or [e-mail] for courteous & immediate
resolution to your problem.
1-800-261-4112Page 1 of 2 www.nationalpublicseating.com
ASSEMBLY INSTRUCTIONS
TABLE ASSIST DOLLY
MODEL #TAD
12x Large
Bolts
2x Small
Bolts
12x Lock
nuts
2x Washers
TOOLS FOR ASSEMBLY
DOLLY FRAME ASSEMBLY
1Attach both front(A) and back(D) frames with the table support
frames(B, C) using two large bolts in each side and tighten with
lock nuts.
A. Front frame
2x Non-Locking Caster
D. Back frame
F. Left vertical
post
B. Right table
support
C. Left table
support
G. Handle
2x Locking
Caster
E. Right vertical
post
H. Strap w/hook
Be sure that all bolts are fully tightened.
17mm or 11/16”
and 10mm or
13/32” Wrench
Side of table support frame
with larger gap goes at the back
INCLUDED HARDWARE
DOLLY COMPONENTS

CASTER INSTALLATION HANDLE INSTALLATION
Congratulations, your dolly is now assembled and ready to be used!
1-800-261-4112Page 2 of 2 www.nationalpublicseating.com
2
4 5
3
Attach Round handle(G) to
right & left vertical posts using
two small bolts and washers.
Install casters by firmly pushing
the stems into the square
tubing of the table support
frames.
Attach both vertical posts(E,
F) to inside of rear of right and
left table support frames using
two large bolts and tighten
with lock nuts in each side.
Place strap loop(H) over
round handle(G).
Locking casters
into the back
Non-locking casters
into the front
Front buckle should
face upwards
E
F