National Public Seating SLT3-2448P User manual

TOOLS FOR ASSEMBLY
Drill
Marker
Polyurethane
Sealant/Adhesive
TABLE COMPONENTS
ASSEMBLY INSTRUCTIONS
STEEL FRAME SCIENCE AND HEAVY DUTY TABLES
(WITH EPOXY RESIN TABLETOP)
Dear Customer, Thank you for your purchase. Although extreme care goes into manufacturing & packaging of
this product, mistakes are possible. If you encounter any missing parts or diculty in assembly, please contact
our customer service Toll Free at 1-800-261-4112 or [e-mail] for courteous &
immediate resolution to your problem.
Tabletop4x LegsFrame4x Gussets
READ ALL INSTRUCTIONS BEFORE INSTALLATION
DO NOT FASTEN ANY SCREWS TO THE TABLETOP
USE OF CASTERS WILL VOID TABLE WARRANTY
INCLUDED HARDWARE
32x Self Tapping
Screws
Drill Bit 4x Nylon-Insert
Lock Nut
WrenchAllen Wrench 16x Screws
DISCARD
DO NOT USE
1-800-261-4112
Page 1 of 3 www.nationalpublicseating.com
IMPORTANT CONSIDERATIONS

Align each gusset onto all four
inside corners of the frame.
Fasten each gusset to the
frame and leg structure by
installing 8 screws through
each plate.
21 Fasten each leg onto frame by
inserting the leg’s hanger bolt
into the corner brackets. Then
fasten the legs using the
included lock nuts.
Ensure that all nuts are fastened tightly.
1-800-261-4112
Page 2 of 3 www.nationalpublicseating.com
Congratulations, your table is now assembled and ready to be used!
5Carefully place frame on top
of sealant on the center of the
underside of the tabletop
Remove frame from tabletop
and then spread a polyurethane
sealant around the full area
where the frame will be placed.
43 Place frame on the center of
the underside of the tabletop,
and mark the inner and outer
edges of the frame on it.
Ensure that the frame is sitting
flat on the tabletop and let it
cure for 24 hours.
6
24

The height of the legs can be easily adjusted by removing the safety screws
and adjusting them to the desired height, the legs can be lifted 1" at a time.
After obtaining the desired height don't forget fasten the safety screws.
21.25"
22.25"
23.25"
24.25"
25.25"
26.25"
27.25"
28.25"
29.25"
30.25"
31.25"
32.25"
33.25"
34.25"
35.25"
36.25"
GLIDE CONFIGURATION
HEIGHT ADJUSTMENT
EXAMPLE
In order to adjust table to your desired height, subtract the tabletop
thickness (listed in below chart) from your desired height, and then follow
the below guideline to adjust the legs to the remaining height.
The leveling glides can be used to add up to an additional .75"
TABLETOP TYPE
Phenolic
Chemical Resistant
Science
High Pressure Laminate
Epoxy Resin
Trespa
SAMPLE MODEL NUMBER
SLT3-2448P
SLT3-2448C
SLT3-2448H
SLT3-2448E
SLT3-2448T
THICKNESS
.75"
1"
1.2"
1"
.75"
Model
Number
SLT3-2448P
Desired Table
Height
30"
Table Thickness
(Listed below)
.75"
Height to
Adjust Legs
29.25"
- =
Ensure that both screws are fastened tightly.
1-800-261-4112
Page 3 of 3 www.nationalpublicseating.com