National Public Seating SLT1 User manual

TOOLS FOR ASSEMBLY
INCLUDED HARDWARE
8x Bolt4x Bolt8x Washer
ASSEMBLY INSTRUCTIONS
SLT1 AND SLT2 with STRETCHERS AND BRACES
TABLE COMPONENTS
2x Braces
Stretcher
4x Rubber Boot
Tabletop
4x Legs
10x End Cap 14x Hammer Nut8x Lock Nut
Wrench
Drill
Allen Wrench
1Fasten each leg to tabletop
structure by installing 2
included washers and 2 lock
nuts through the holes at the
tabletop structure into the
bolts in the leg.
2Place the rubber boots in
each leg to protect them.

3Insert 2 hammer nuts into the
2 holes at both ends of each
brace. Make sure to align
them parallel to the length of
the brace.
5
4Fasten each end of the brace
to each leg by installing 2 of
the larger included bolts
through the holes on each
leg and into the brace.
7Add the end caps in all
expose holes.
Congratulations, your table is now assembled and ready to be used!
Dear Customer,Thank you for your purchase. Although extreme care goes into manufacturing &
packaging of this product, mistakes are possible. If you encounter any missing parts or diculty in
assembly, please contact our customer service Toll Free at 1-800-261-4112 or
[e-mail] for courteous & immediate resolution to your problem.
6Fasten each end of the
stretcher to each brace by
installing 2 of the shorter
included bolts through the
holes at the center each
brace and into the ends of
the stretcher.
Repeat step number 3 now for the stretcher.
ASSEMBLY INSTRUCTIONS SLT1 AND SLT2 STRETCHERS AND BRACES