National Public Seating Kangaroo 6722 HB User manual

1-800-261-4112Page 1 of 2 www.nationalpublicseating.com
STOOL COMPONENTS
1
Double check all Bolts to be tightened securely before use. Check all Bolts periodically.
Failure to completely tighten the Bolts may result in tipping and possible injury!
INCLUDED
HARDWARE
TASK STOOL
Seat and Backrest
Bolts
x6
Allen Wrench
D
(or )
ASSEMBLY INSTRUCTIONS
6722 HB | POLYURETHANE TASK STOOL
1
D
x1
Ax1
Bx1
C
x1
Dx1
Ex1
F
x5
Gx5 H
G
x1
I
3
2
Insert Glides or
Casters into each of
the five legs of Base .
Insert Column firmly
into the center of Base .
G
H
A
C
Slide Footring onto
Column with Ring
facing upwards and
place at desired location.
Slide Column Cover
over Column .
Tighten Footring knob
well to assure that it
stays in place.
BASE/ COLUMN ASSEMBLY
NOTE: There is a rubber sleeve in the center of Footring. To prevent scratching of Column when
tightening knob, be sure that the sleeve is in place, and be careful to tighten over the rubber sleeve.
2
x1
J
J
CC
I
(or )
G
J
A

Dear Customer, Thank you for your purchase. Although extreme care goes into manufacturing & packaging of this product, mistakes are possible.
If you encounter any missing parts or diculty in assembly, please contact our customer service Toll Free at 1-800-261-4112 or
[e-mail] for courteous & immediate resolution to your problem.
1-800-261-4112Page 2 of 2 www.nationalpublicseating.com
Congratulations, your Task Stool is now assembled and ready to be used!
Double check all Bolts to be tightened securely before use. Check all Bolts periodically.
Failure to completely tighten the Bolts may result in tipping and possible injury!
12
SEAT ASSEMBLY
13
2
BACKREST ASSEMBLY
Align Seat Mounting Plate/Backrest Arm
with screw holes in underside of Seat .
Loosely insert all four Seat Bolts throgh
holes on Seat Mounting Plate/Backrest Arm
into screw holes on underside of Seat
and tighten only slightly, using the provided
Allen Key . After all four Seat Bolts are
properly, inserted tightly secure them in a
cross fashion.
Once Mounting Plate has been attached
to Seat , place Seat over upper
portion of Column and push down firmly.
Place Backrest Bracket
onto top of Plate .
Hold Backrest over
Bracket and allign holes
on Bracket to holes on
Backrest
Using the provided Allen
Key , tightly secure the
two Backrest Bolts
to Backrest .
2
1
F
B
D
F
F
D.
B
E
2
B
1
E
2
E
E
C
ASSEMBLY INSTRUCTIONS
6722 HB | POLYURETHANE TASK STOOL
B
D