National Public Seating Kangaroo Stool 6722HB User manual

1
Model 6722HB Kangaroo Stool Assembly Instrucons
Base/Column assembly
1. Insert Glides (A) or Casters (B) into each of the ve legs of base (C).
2. Insert column (D) rmly into center of base.
3. Slide footring (F) onto column with ring facing upwards and place at
desired locaon.
4. Slide column cover (E) over column.
5. Tighten footring knob well to assure that it stays in place. Note:
There is a rubber sleeve in the center of footring. To prevent scratch-
ing of column when ghtening knob, be sure that the sleeve is in
place and when ghtening be careful to ghten over the rubber
sleeve.
Seat assembly
1. Align seat mounng plate/backrest arm (I) with screw holes in underside of seat (J).
Loosely insert all four seat bolts (G) through holes on seat mounng plate/backrest
arm (I) into screw holes on underside of seat (J) and ghten only slightly, using the
provided Allen key.
Aer all four seat bolts (G) are properly inserted, ghtly secure them in a crossed
fashion.
2. Once seat mounng plate has been aached to seat, place seat over upper poron
of column and push down rmly.
Backrest assembly
1. Aach backrest bracket plate (M) to rod on top of backrest arm by sliding the rod
into side holes of plate.
2. Place backrest bracket (L) onto top of plate.
3. Hold backrest (K) over bracket and align holes on bracket to holes on backrest.
4. Using the provided Allen key , ghtly secure the two backrest bolts (H) to backrest.
Page 1

2
Page 2