Nauticam 36182 User manual

Instruction Manual for Macro port for
Canon EF-EOS M adaptor and EF-S 60mm
f/2.8 Macro USM
PN# 36182
F ORE ORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM we pride ourselves in the ability to recognise the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Each product is individually inspected and water pressure tested to ensure
optimum quality.
Please read this manual carefully before using the product this will maximise
its performance as well as its lifetime.
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use. This warranty only applies to products purchased from authorised
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service please contact your regional authorized
service centre(s). Please note that this warranty only applies when the
product is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage of any nature to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorised modifications and/or repairs of our products will automatically
invalidate the warranty.
M OUNTING THE P ORT T O A H OUSING
Detach A from the port by turning it anti-clockwise while holding B firmly.
Install the camera body only into the housing.
*Please refer to the housing manual for installing camera into the housing.
Align the port mounting indices of B and the housing. Gently push B into the
port opening of the housing until it cannot go in any further.
*Please refer to housing manual for locking and un-locking the port.
Make sure the two knobs are at its most outwards position before mounting/
un-mounting the lens. The knobs should be left at this position until it is made
sure that the lens and gear is properly installed.
B
A

Remove the O-ring from A inspect for any damage and lightly coat it with the
provided lubricant. Clean the O-ring groove before placing it back.
Verify that the threaded section of B and sealing surface are clean and free
from foreign material.
Align the external threaded section of A and the internal threaded section of B.
Attach A on B by holding the housing firmly and turning A clockwise until it
cannot go in any further.
Engage the lens AF/MF switch by pushing in the upper knob then turn the
knob both ways to check if the lens is switching between auto and manual
focus.
Engage the gear by pushing in the lower knob then turn the knob both ways
to check if the lens manual focusing is functioning.
To un-mount the port reverse the above steps.
Upper knob
Lower knob