Neopost DS-35 Manual

1
ENGLISH
Before you start
1. Make sure that the system is suitable for the local mains voltage. Refer to the type
plate.
2. The power connection must be easily accessible. Place the system near a socket
outlet with protective earth connection.
Unpacking instructions
1. Slide the foam blocks with the system out of
the box. Use the grips in the foam blocks to pull
the blocks.
2. Lift the catch tray parts out of the foam blocks.
3. Turn the foam blocks on its side.
4. Remove the upper foam block.
5. Make sure that the following parts are
delivered:
-Documentsystem
- Document feeder block
-Catchtray
- Accessory box
The accessory box contains:
-Powerlead
- 4 supports for the document feeder
- 2x paper guide LH
- 2x paper guide RH
- 4x short (sharp) insert fingers*
- 4x long (sharp) insert fingers*
-OperatorManual
-Quickstartguide
-Thisguide
* Note: These insert fingers (black plastic
parts) are not required during installation.
Please store these parts with the machine.
6. Lift the system and place it for example on the
optional furniture.

2
Install the feeder block
1. Hold the feeder block slightly inclined as
shown in the figure.
2. Lower the block until the grips click on
the pins.
3. Rotate the feeder block until it clicks on
the system.

3
ENGLISH
4. Install the four document supports on the
feeder trays.
5. Connect the connector.
6. Install the two paper guides LH and two
paper guides RH on the feeder trays.
Install the envelope catch tray
To install the envelope catch tray:
1. Hold support Ainclined and slide the
arms into the slots.
2. Move the support down until it clicks onto
the catch tray.
3. Move the catch tray until the clamps hold
the feet of the system.
4. Adjust the catch tray to the correct
envelope size.
1
2
A

4
Fill the sealing liquid
reservoir
When you want to seal envelopes,
the sealing liquid reservoir must be
filled.
1. Open the system with the
button on the left side.
2. Lift the sealing liquid reservoir
Dwith the blue handles A
carefully out of the system.
3. Remove the strip Cfrom the
reservoir.
4. Fill the three reservoirs with
sealing liquid.
5. Make sure the brushes Bare
moistened sufficiently.
6. Replace the liquid reservoir.
7. Close the system.
Before you start the job, wait
approximately 5 minutes for the
brushes to moisten.
Connect the system to the mains power
supply
To start up the system:
1. Connect the system to the mains power
supply.
2. Use the power switch to switch the system
on. The power switch is located at the back of
the system.
3. Press the power button next to the display.
The touch screen shows the home menu.
Set language
1. Press the MENU button.
2. Select the LANGUAGE SETTINGS button.
3. Select the applicable language and press the save button.

5
ENGLISH
Test the system
1. Load the document feeder trays.
2. Load the envelope hopper.
3. In the home menu, press the (new job)
button.
4. Configure the job to feed a sheet from every
feeder.
5. Press the 1x button. If necessary adjust
address position, insert position (supervisor
menu) and sealing position (supervisor
menu).
Define jobs
Define any jobs according to the customer’s wishes / applications.

6