Ness LUX Quick start guide
2
INTRODUCTION
DETECTION COVERAGE
PET AWARE MODE
COMPONENTS
4
MOUNTING LOCATION
INSTALLATION
NOTE. Ensure that LUX HW is not installed in
the same area as a strong source of infrared
energy (such as an IR CCTV camera) as this
may interfere with the operation of the light
sensor.
MOUNTING HEIGHT
NIGHT LIGHT OPERATION
SENSOR MASK
6
SWITCH 1 - RANGE
SWITCH 2 - PULSE
SWITCH 3 - PET
The sensor mask must be in position 3
when Pet Aware mode on enabled.
SETTINGS
SWITCH 4 - LED
SWITCH 5 - LIGHT MODE
SWITCH 6 - LIGHT LEVEL
2
4
6
7
TERMINALS
+12V / 0V
ALARM
TAMPER
LIGHT IN
SENS OUT
The output is OFF
The output is ON
FAST OUT
The output is OFF
The output is ON
+12V
D8X/D16X PANEL NESS LUX HW DETECTOR
2K2
+12V Tamper aLarm 0V +12V
OUT
FaST SeNS LIGHT
OUT IN
8
SPECIFICATIONS
Table of contents
Other Ness Security System manuals
Ness
Ness PRO-LD User manual
Ness
Ness Radio Siren Quick start guide
Ness
Ness Guardpost User manual
Ness
Ness Guardpost User manual
Ness
Ness 5000 Series User manual
Ness
Ness Guardpost User manual
Ness
Ness Guardpost Assembly instructions
Ness
Ness Lux Quick start guide
Ness
Ness SmartLiving 505 Assembly instructions
Ness
Ness 5000 Series User manual
