Noble House Home Furnishings 70289 User manual

Caution : You must read this before you proceed
Bench
Noble
House Home Furnishings LLC Page 1 of 6

Label Picture Description QTY
A Left leg 1
B Right Leg 1
C Top 1
Label Picture Description QTY
①Bolt( M8*64mm) 9
②Flat Washer 9
③Allen Wrench 1
Before
Beginning
Assembly:
X 9
X 9
Noble
House Home Furnishings LLC Page 2 of 6

Step 1
Overview
This Bench has multiple parts and may require up to 30 mins to assemble.
To give you an overview of the Bench parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
herebelow to familiarise the parts and steps before assembly.
Unpack and place all parts on a clean, non-marring surface.
FRONT FACING
Top (C)
Right
Leg (B)
Noble
House Home Furnishings LLC Page 3 of 6

Step 2
Step 3
Place the Top (C) with its one side face skywards onto a clean, soft surface to
avoid any scratches or damages to the product.
Align the tenon of Top (C) into the Mortise of Left Leg (A) as shown above.
Then, affix the Top (C) with Left Leg (A) by using Short blots (①)+Flat
Washer(②) and Allen Wrench (③)
DO NOT FULLY TIGHTHEN BOLTS.
Then continue position Top (C) as shown in picture above.
Align the wooden dowel into the positions in the Legs.
Then, affix the Right Leg (B) with Top (C) by using Short Bolts (①)+Flat
Washer(②) and Allen Wrench (③)
DO NOT FULLY TIGHTHEN BOLTS.
A
C
①
①
B
C
NOTE : Each leg numbred.
Please match accroding to respective
markings.
①
①
②②
②
②
Noble
House Home Furnishings LLC Page 4 of 6

Step 4
Step 5
With the help from your partner, turn the Bench to rest on Top (C) so that
Right Leg (B) is now facing skywards.
Repeat the same process by affixing Bolts (①), (②) to designated points.
DO NOT FULLY TIGHTHEN BOLTS.
Turn the Bench right side up.
Place the Bench on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Bench.
This would help to align all the parts at all the joint areas.
Then get off the Bench, and in a sequential manner, proceed to tighten all
blots.
To tighten the blots at the base of Top, do secure assistance from your adult
partner(s).
You may be required to turn the Bench, to gain easy access to the secure
points.
Noble
House Home Furnishings LLC Page 5 of 6

Turn the Bench in a synchronised manner.
CAUTION 1: When tightening these blots, tighten sequentially.
DO NOT tighten any blots fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the blots and execute this same process.
IF Bench IS NOT STABLE , IT COULD LEAD TO DAMAGING THE
PRODUCT.
Ensure all blots are fully locked into position.
The Bench is ready to be used.
Caution 2: This Bench can only be used on a flat, level surface.
Noble
House Home Furnishings LLC Page 6 of 6