Noble House Home Furnishings Table User manual

Assembly Instructions
Caution: You must read this before you proceed
Table
CAUTION : This table is NOT a TOY.
Noble house Home Furnishings LLC Page 1 OF 6
Label Picture Description QTY
A Table Top 1
BTable Leg with Pre-
attached Leveller 4
CCentral Square
Support Ring 1
D Cover 1
E Ice Bucket 1
Parts list
CAUTION : This table is NOT a TOY.
Keep your child / children at bay in the process of assembly.
Noble house Home Furnishings LLC Page 1 OF 6

Label Picture Description QTY
①Stud(M8*40mm) 5
②Washer(8mm) 9
③Spring Washer(8mm) 9
④Nut(8mm) 9
⑤Nuts Cap( 8mm ) 5
⑥Screwdriver 1
⑦Spanner 1
Hardware
Assembly Preparation
Before
Beginning
Assembly:
Page 2 OF 6 Noble house Home Furnishings LLC

Assembly Step
Overview
This table has multiple parts and may require up to 30 minutes to
C(Central Square
Support Ring)
A(Table Top)
B(Table Leg with Pre-
attached Leveller)
D(Cover)
E(Ice Bucket)
FRONT FACING
Step 1
Unpack and place all parts on a clean soft surface.
assemble.
To give you an overview of the table parts, the above picture is to help
you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Noble house Home Furnishings LLC Page 3 OF 6

Step 2
Step 3
Turn the Table Top upside down on to a soft surface that does not scratch
the table top.
Attach four Table Legs(B) to the contact points on the Table Top(A) with
Bolts(①), Spring Washers(③) , Washers(②) and Nuts(④) using
Screwdriver(⑥) and Spanner(⑦).
DO NOT OVER TIGHTEN all Bolts.
A(Table Top)
②
B⑦
②
③
④
①
A
Step 3
Attach the Central Square Support Ring(C) to Table Leg(B) using
Washers(②), Spring Washers(③) and Nuts(④) with the Spanner(⑦).
Repeat the same tightening at all 4 poins of the Legs.
DO NOT OVER TIGHTEN, yet.
C
B(Table Top
-
④
③
B
A
②④
Page 4 OF 6 Noble house Home Furnishings LLC

Step 4
Step 5
Turn the Table rightside up.
Then, proceed to tighten all Bolts and Nuts.
Add Nuts Cap(⑤) to the Nut(④).
Put the Ice Bucket(E) into the middle housing of the Table top(A).
Then put the Cover(D) over the Ice Bucket (E) .
pre
-
installed
⑤
When necessary adjust the Pre-installed Levellers at the end of each
Table Leg until the Table is level with the groud.
Your Table is now ready for use.
Adjust
height for Adjust low
for balance
Noble house Home Furnishings LLC Page 5 OF 6

Page 6 OF 6 Noble house Home Furnishings LLCPage 6 OF 6 Noble house Home Furnishings LLC