Noble House Home Furnishings TABLE User manual

Assembly Instructions
TABLE
CAUTION: You must read this before you proceed
Noble House Home Furnishings LLC 1

Hardware
No. Qty
Description
Picture
1
3
2
Parts List
No. Qty
Description
Picture
A
1
Table Top
9
9
2
Bolts
(M6x55mm)
Washers
Allen Key
B
4
Leg
Noble House Home Furnishings LLC 2

Assembly Preparation
Before Beginning Assembly
Read instruction, cover to cover.
Have 2 adults on hand for assembly.
Do not assemble on flooring or carpet.
Assemble on a clean non-marring surface (packing foam).
Save all packaging until finished
Assembly Steps
This Table has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Table parts, the above picture is to help you put
the various parts into perspective. Please read through the instructions below
to familiarise yourself with the parts and steps before assembly.
Table Top (A)
Leg (B)
Step 1
Unpack and place all parts on a clean, non-marring surface
Noble House Home Furnishings LLC 3

Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until
evenly secured.
When tightening the Bolts tighten sequentially.
Do no tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above
process.
Your Table is ready for use
This Table can only be used on a flat, level surface.
Step 2
Palce the Table Top (A) facedown onto a clean, non-marring surface.
Insert Legs (B) into the mounting positions on the Table Top (A), then attach using
Bolts ( ), and Washers ( ) with Allen Key ( ) as shown above.
Do not fully tighten the Bolts.
1
Step 3
Noble House Home Furnishings LLC 4
2 3

Noble House Home Furnishings LLC 5