Noble House Home Furnishings Bench User manual

Label Picture Description QTY
A Bench Seat Panel 1
Parts List
Assembly Instructions
Caution: You must read this before you proceed
Bench
Caution: This Bench is NOT a TOY
Keep your chil /chil ren at bay uring the assembly process.
Whenever moving/lifting the Bench an to prevent amage to the Bench, two a ults are nee e
to execute these actions.
Noble House Home Furnishings LLC
Page 1 of 7

B Iron Leg Frame 2
CLeg Support Bar 2
Label Picture Description QTY
①
Bolt
(M6x20mm) 13
②
Washer 13
③Screw
(M6x45mm) 3
④Allen Key 1
Har ware
Noble House Home Furnishings LLC
Page 2 of 7

Before Beginning Assembly:
Assembly Preparation
Noble House Home Furnishings LLC
Page 3 of 7

Assembly Steps
Overview
This Bench has multiple parts an may require up to 15 minutes to assemble. To give you an overview of the
Bench parts, the above picture is to help you put the various parts into perspective. Please rea through the
instructions below to familiarise yourself with the parts an steps before assembly.
Step 1
Unpack an place all parts on a clean, non-marring surface.
Iron Leg Frame (B)
Bench Seat Panel (A)
FRONT FACING
Leg Support Bar (C)
Noble House Home Furnishings LLC
Page 4 of 7

Insert the Leg Support Bar(C) with pre-fixe iron owels into the housings on Iron Leg Frames(B) as picture .
Note: You might need to apply a little pressure to the eg Panels pushing outwards slightly to insert
the eg Support Bar(C).
Attach Leg Support Bar(C) to Iron Leg Frames(B) using Bolts(①), an Washers(②) with Allen Key(④).
Do not fully tighten the Bolts.
Repeat the same process with the remaining Leg Support Bar(C).
Step 2
Step 3
Position Bench Seat Panel(A) face own on a clean, non-marring surface.
Attach Iron Leg Frames(B) to Bench Seat Panel(A) using Bolts(①), an Washers(②) with Allen Key(④).
Do not fully tighten the Bolts.
1
4
2
Iron Dowel
2
1
4
B
A
C
B
Noble House Home Furnishings LLC
Page 5 of 7

Step 4
Attach the Iron Leg Frames(B) to the Bench Seat Panel(A) using Screws(
③
) with Allen Key(
④
).
Do not fully tighten the Screws.
Step 5
4
3
B
A
Adjust Pre installed Levellers height for balance
Noble House Home Furnishings LLC
Page 6 of 7

Your Bench is rea y for use.
This Bench can only be used on a flat, level surface.
Step 6
Stan the Bench up.
Place the Bench on a LEVEL surface.
Inspect it an make sure all parts are a equately connecte .
Gently an gracefully, sit onto the Bench.
This pressure will help the Legs an Bench reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are foun procee to tighten the Bolts an Screws in a sequential manner, until evenly secure .
When tightening the Bolts and Screws tighten sequentially.
Do not tighten any Bolt or Screw fully and then move on towards the next one.
With assistance from your a ult partners, a just the Levellers to esire height to avoi wobbles.
Noble House Home Furnishings LLC
Page 7 of 7