Noble House Home Furnishings Chair User manual

Label Picture Description QTY
A Chair Seat 1
B Back Cushion 1
C Leg 4
Assembly Instructions
Caution : You must read this before you proceed
CHAIR
Parts List
Noble house Home Furnishings LLC 1 of 5

Label Picture Description QTY
①Plastic Washer 7
Before Beginning Assembly:
Assembly Steps
OVERVIEW
Hardware List
Assembly Preparation
x1 x4 x1 x7
Chair Seat(A)
Leg(C)
Back Cushion(B)
FRONT FACING
Noble house Home Furnishings LLC 2 of 5

Step 1
Step 2
This Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Chair parts, the above
picture is to help you put the various parts into perspective. Please
read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Position the Chair Seat(A) on a clean, non-marring surface.
Remove the four Legs(C) and Plastic Washer(①) under the Back Cushion(B)
as shown above.
Chair Seat(A)
Chair Seat(A)
x7
①
x4
Back Cushion(B)
Leg(C)
Noble house Home Furnishings LLC 3 of 5

Put your Chair Seat(A) right side up.
Place Back Cushion(B) on the Chair Seat(A) as shown above.
Your Chair is ready for use.
Your Chair can only be used on a flat, level surface.
Step 3
Step 4
Position the Chair Seat(A) facedown on a clean, non-marring surface, as
shown.
Install the Leg(C) onto the bottom of the Chair Seat(A) by putting a Plastic
Washer(①)(optional but improves security and tightness) onto the threaded
stem. Insert the threaded stem into the threaded hole at each corner of the
bottom of the Chair Seat(A). Tighten the leg by turning clockwise.
Repeat the same steps to install the remaining 3 legs.
Chair Seat(A)
Back Cushion(B)
Noble house Home Furnishings LLC 4 of 5

Noble house Home Furnishings LLC 5 of 5