Noble House Home Furnishings Loveseat User manual

Label Picture Description QTY
A Backrest Panel 1
B Seat Base 1
C Wing 2
D Leg 4
Assembly Instructions
Caution: You must read this before you proceed
Loveseat
Parts List
Page 1 OF 6

Label Picture Description QTY
①Bolt
(M8x20mm) 13
②Spring Washer 13
③Washer 13
④Bolt
(M8x60mm) 3
⑤Washer 3
⑥Allen Key 1
Before
Beginning
Assembly:
Hardware
Assembly Preparation
Page 2 OF 6

Step 1
Step 2
Assembly Steps
Overview
This Loveseat has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Loveseat parts, the above picture is
to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
With Assistance from your adult partner, position the Seat Base(B) facedown
on a clean, non-marring surface, as shown.
Upzip the pouch and remove the Legs(D) and Hardware.
Close the pouch.
Attach Legs(D) to Seat Base(B) using Bolts(①), Spring Washers(②), and
Washers(③) with Allen Key(⑥).
Do not fully tighten the Bolts.
Backrest Panel (A)
Wing (C)
Seat Base (B)
Leg (D)
(D)
(B)
(D)
(B)
(B)
Legs and
Hardware
Page 3 OF 6

Step 3
Step 4
Step 5
Stand the Seat Base(B) up.
With assistance from your adult partner, lift the Backrest Panel(A) and insert
the Connectors on the Backrest Panel(A) into the Connectors on the Seat
Base(B).
Push firmly down on Backrest Panel(A) to esure it is fully locked into position.
Insert the Connectors on the Wings(C) into the Connectors on the Backrest
Panel(A).
Push firmly down on Wings(C) to esure they are fully locked into position.
(B)
(D)
(B)
Connector
(A)
Connector
Connector
(A)
(B)
(C)
(D)
Page 4 OF 6

Step 6
Step 7
Step 8
Your Loveseat is ready for use.
This Loveseat can only be used on a flat, level surface.
Upzip the pouch at the bottom of Seat Base(B).
Attach Backrest Panel(A) and Seat Base(B) by using Bolts(④) and
Washers(⑤) with Allen Key(⑥).
Tighten the Bolts fully in a sequential manner.
Then close the pouch.
Stand the Loveseat up.
Place the Loveseat on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit on the Loveseat.
This pressure will help the Legs and Seat Base reach full alignment status.
Then get off the Loveseat, and carefully place the Loveseat facedown.
Then proceed to tighten all Bolts at all joints in a sequential manner.
(D)
(B)
Page 5 OF 6

Page 6 OF 6