Noble House Home Furnishings Table User manual

Caution : You must read this before you proceed
Table
Label Picture Description QTY
A Leg 2
B Table Top 1
Label Picture Description QTY
①Bolt(M6*15MM)
Flat Head 9
②Bolt(M6*30MM)
Flat Head 9
③Washer 9
④Allen Key(4MM) 1
⑤Plastic plug 1
Noble House Home Furnishings LLC Page 1 OF 6

Before
Beginning
Assembly
:
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Table parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
FRONT FACING
Table Top (B)
Leg (A)
*9 *9 *9
Noble House Home Furnishings LLC Page 2 OF 6

Step 1
Open the carton and place all the parts onto a clean, non-marring surface.
1.1) As shown in the figure above, tilt the seat plate (B) slightly to one side, and place the Leg tube
(A) on the seat plate (B).
1.2) Attach the Leg(A) to the Table Top(B) with Bolts(①) using the Allen Key(④) as pictured.
1.3) Attach the Leg(A) to the Table Top(B) with Bolts(②) and Washers(③) using the Allen Key(④)
as shown above.
Do not fully tighten the Bolts.
1.1
②
④
③
①
1.3
1.2
④
Leg (A)
Table Top (B)
Noble House Home Furnishings LLC Page 3 OF 6

Step 2
2.1) As shown in the figure above, tilt the seat plate (B) slightly to one side, and place the Leg tube
(A) on the seat plate (B).
2.2) Attach the Leg(A) to the Table Top(B) with Bolts(①) using the Allen Key(④) as pictured.
2.3) Attach the Leg(A) to the Table Top(B) with Bolts(②) and Washers(③) using the Allen Key(④)
as shown above.
Do not fully tighten the Bolts.
2.1
Leg (A)
Table Top (B)
2.2
④
①
②
③
④
2.3
Noble House Home Furnishings LLC Page 4 OF 6

Step 3
Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and the Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles after tightening, loosen the Bolts and execute the same above
process.
If the Table is not Stable it could lead to damage of the product.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Additional Hardware:
Insert the adjusting foot pad (⑤) into the Leg tube(A) , as shown in the figure above.
Table is ready for use.
This Table can only be used on a flat, level surface.
Adijust Pre-installed Levellers
height to achieve balance
⑤
Noble House Home Furnishings LLC Page 5 OF 6

Noble House Home Furnishings LLC Page 6 OF 6