UI/L22056/M66119/01/14/Iss4
5 - Position potty on supports brackets (if
required) and place grey vinyl seat pad over the
moulded seat.
6 - Clip the two footrests into position, by fitting
them from the side, over the two studs on either
side of the front of the commode frame and
rotating them towards the front of the frame until
they click into place. Check the “swing away”
and “tilt up”operation of the footrests.
7 - Check the operation of the braked castors
and that the commode runs smoothly on a level
surface.
Caution: If you suspect a fault for any reason
with your commode, do not use and contact your
supplier immediately.
8 - The commode is now ready for use.
Safety precautions:
·Do not exceed Maximum User Weight.
·Always ensure the product is suitable for
your requirements; if in doubt, check with a
health professional.
·Always ensure all castors have the brake
applied and are in a forward aspect (not
trailing) and the footrests are up when sitting
onto or rising from the commode to reduce
the risk of tipping. Note: Footrests should
only be used to support the feet and should
not be used to stand on when entering or
leaving the commode.
·Check that no parts of the body are outside
the commode if passing through doorways.
·Take particular care when using the product
on damp surfaces.
·Before every operation inspect the product to
ensure it is fit for purpose; see Maintenance.
·Damaged, worn or missing components must
be replaced before further use by an
approved repairer.
Commode Bucket Cleaning
Note: protective gloves are recommended when
emptying the commode potty.
To remove the commode bucket, simply slide
the bucket out from the chrome runners at the
rear of the commode. Cover the top of the
bucket to avoid splashing. Carefully dispose of
the contents into a proper sluice or toilet.
Caution: Never empty contents into an open
drain, sink or basin. This could cause a
serious health risk.
Clean out the residue with a suitable disinfectant
and refit to the commode.
It is recommended that the seat is also wiped
with a disinfectant wipe or mild solution after
each use. Also wipe down the frame if any
spillages are apparent using a mild disinfectant
solution/wipe.
Note: NRS Healthcare offers a range of
gloves and cleaning solutions to assist in the
effective decontamination of the potty and
commode.
For further information contact customer
services on: 0845 120 4522
Commode cleaning
Simply hose down/wash down or pressure wash with
a mild detergent solution, ensuring all detergents are
washed off thoroughly.
Wipe the commode thoroughly dry, paying particular
attention to all joints and abutments. Do not use an
abrasive cloth for drying
Caution: you must not use abrasive cleaners or
cleaners that attack chromium plating as this will
affect the integrity of the chromium plated
surface.
It is recommended that all joints, abutments and
castors are then sprayed with a water dispersing
agent such as WD40; this will give your commode
greater longevity and avoid premature rusting.
Maintenance
Check all components while in service on a regular
basis, once a week is recommended (and, following
decontamination, prior to reissue).
Ensure that all components are secure.
This includes:
The tightness of nuts and hand wheels.
The tightness, condition and operation of castors
including brake function.
Check all E-clips are securely engaged.
Check the condition and operation of footrests.
Check upholstery and moulding for splits.
Tighten and/or replace as necessary before re-use.
If in any doubt, please do not use or issue, but
contact your supplier for service support.
Manufactured for
NRS Healthcare
Sherwood House, Cartwright Way,
Forest Business Park, Bardon Hill,
Coalville, Leicestershire.
LE67 1UB, UK
Tel. Main Office: 0330 100 00 98
Tel. Customer Services: 0845 120 4522
This product is from a range of over 3000 daily
living aids available from NRS Healthcare.
To view the full range visit: www.nrs-uk.co.uk
or request a catalogue from the above number.
