NUCANOE 2520 Programming manual

2520 –Frontier Console
Assembly & Installation Instructions
Compatible With:
1. Insert T-Connectors into side panels.
2. Connect Side Panels to Bottom Panel as shown,
fasten using 4 self-tapping screws though bottom
into T-Connectors.
3. Place top panel on side panels, fasten using self-
tapping screws through top into T-Connectors.
4. Install bungee webbing in front and back. Tie
knots on ends below the bottom panel.
Installed and outfitted Frontier Console

CellBlok Mounting Locations:
5. Install 8” Track sections using 8-32
machine screws with lock nuts. Position
on sides and your choice of front or back.
6. a) Install Washer
and Rubber Spacer onto
Mighty Bolt. Insert into bow
end of Freedom Track.
b) Install 2.5” Truss
Bolt in Freedom Track,
followed by plastic spacer
and rubber spacer. Secure
console with Mighty Knobs.
6. a)
6. b)
6. a)
6. b)
Bow
To mount CellBlok below console: Install using two
holes on the forward part of the console panel.
To mount CellBlok on top of console: If mounting on
top, do not install track on whichever side you choose
to mount the CellBlok. Install using two holes on the
left or right side of console.
CellBlok Mounting Locations: