
NuCanoe CellBlok
Installation Instructions
#4221
2. If mounting to bow tracks (Flint and Frontier 12 only) or center track (Flint only) follow adapter plate
mounting instructions. Else secure to desired location with Might Bolts and Mighty Knobs.
1. Assemble CellBlok. Install track onto CellBlok using smallest
self-tapping screws included with CellBlok hardware on
outer-most holes of track. Drill out center hole on CellBlok
cover and secure track with 5/8” flat head screw and 8-32
locknut.
A. Insert track sliders into track and align
with mounting holes.
B. Secure plate to track - with tapered end
towards the bow - using appropriate screws.
Included Hardware: [1] 8-32 x 5/8“ Flat Head Screws [1] 8-32 Locknut
[2] Track Sliders [2] 3/4” Flat Head Screws [2] 1” Flat Head Screws [6] Fender Washers
[2] 1¾“ Mighty Bolts [2] Mighty Knobs
(a) If mounting to
bow track, use 3/4”
flat head screws and
mount using
outermost holes.
(b) If mounting to
center track, use 1”
flat head screws and mount using center holes. Due to
variations in plastic, 1 - 3 washers may need to be installed
between track and adapter plate.
Self-tapping
screws
8-32 x 5/8”
screw and
locknut
Mounting Adapter Plate on Flint:
A. Insert track sliders into track and align
with mounting holes.
B. Secure plate to track - with tapered end
towards the bow - using 3/4” flat head screws.
Mount plate to track
using the center
hole on the bow end
of the plate, and the
inner-most hole on
the stern end.
Mounting Adapter Plate on Frontier 12: