NUCANOE 2525 User manual

Pursuit Console Assembly & Installation
Item #2525
2. Connect Back Panel into Bottom Panel. Secure
using self-tapping screws through bottom
panel into T-Connectors.
1. Lay out Panels as pictured.
• Drawer Front Panel has 3 channels and
flared sides.
• Side Panels are longer and symmetrical.
• Back Panel has one channel and corner
notches.
Insert 8 x T-Connectors into all Insert 8 x T-Connectors into all T-Slots in
the Console panels.
Side
Side
Back
Drawer Front
3. Connect Side Panels (1), then connect Drawer
Front Panel (2). Secure using self-tapping
screws through bottom panel into
T-Connectors.
(1)
(1)
(2)
4. Install Console Slides on Top Panel.
(a) Align Slides with pre-drilled holes. Position slides so the
“ledges” face each other (see Fig. 1). Secure with self-tapping
screws, ensuring screws go through counter-sunk side.
(b) Insert Back of Drawer in
between Slides (see Fig. 1). It is a snug
fit and may take a bit of pressure to
slide into the Drawer grooves.
Fig. 1

5. Install Tracks on desire end of top panel using pre-drilled holes and machine screws with
locknuts. Install any desired track-mountable devices.
6. Insert in the Bow Crate Space on Pursuit and secure with Mighty Bolts & Mighty Knobs.
7. Install bungee cord for use as door latch.
8. Install desired accessories on either the left or right side of Console. The hole patterns on
Console are compatible with:
SwitchBlade Transducer Arm
CellBlok
Anchor Wizard
SwitchBlade
SwitchBlade
Anchor Wizard
CellBlok