Nureva HDL300 Service manual

Nureva Dual HDL300
Setting Guide

Copyright © Lumens. All rights reserved.
1. Get Hardware connection
Nureva Dual HDL300

Copyright © Lumens. All rights reserved.
1.1 Get Hardware connection
Nureva Dual HDL300 Microphone
HDL300 connect module
Meeting Room PC
(Windows OS)
Cable define
Cat5e
HDMI cable
USB 2.0 cable
CamConnect Processor
(AI-BOX1) Display
Display
Lumens PTZ Camera

Copyright © Lumens. All rights reserved.
2. Install & step by
Nureva Console client
Nureva Dual HDL300

Copyright © Lumens. All rights reserved.
2.1 Install Nureva Console client
Using Console client for step Nureva DHL300
Download [Console Client]
https://support.nureva.com/97341-download/win-mac-download-nureva-console-client

Copyright © Lumens. All rights reserved.
2.2 Setup Nureva Console client
After Nureva Console client setup is completed, launch Console client app
and USB cable connect from Nureva connect module to PC

Copyright © Lumens. All rights reserved.
2.3 Setup Nureva Dual HDL300 integration
A: Drag the vertical scroll bar of the Console client down
B: Scroll down until you see the 'Integrations' option
C: Click the down arrow of [Local integrations]
A
BC

Copyright © Lumens. All rights reserved.
2.4 Setup camera tracking integration
A: Click the scroll bar to enable [Network integration settings]
B: Copy this IP, and we will use it to fill it in [Device IP] of CamConnect Pro
C: Fill the IP of CamConnect Pro and Enter.
A
B
C

Copyright © Lumens. All rights reserved.
2.5 Setup camera tracking integration
A: Fill the IP which copy from Nureva Console client [Network
integration settings]
B: Press [Apply] button and the toggle [connect] bar to enabled
※Nureva default port is 8931. Please confirm the port is allowed to
connect with your PC.
AB
Nureva: Dual HDL300

Copyright © Lumens. All rights reserved.
3. Set angle position setting
Nureva Dual HDL300

Copyright © Lumens. All rights reserved.
3.1 Setup angle position setting
Note: “Azimuth Angle” maximum angle range is from -70 to +70 degrees,
which makes 0 degree as its center point.
The schematic diagram above shows a sound source detected in the 0
degree region.
0
-70
70