NXP Semiconductors S32K324 User manual

EXTERNAL USE
S32K324 DUAL CORES
DEBUG WITH
P&E MULTILINK

1EXTERNAL USE
•Debug S32K324 Project when “CM7_1_ENALBE=1”
•Debug S32K324 Project when “CM7_1_ENALBE=0”
Example application
used in this document

2EXTERNAL USE
Debug S32K324 Project when “CM7_1_ENALBE=1”
•CM7_1 is enabled during boot. Debugger can connect to it during
the debug launch.
•Check CM7_0 and CM7_1 projects debug settings
•Launch Group

3EXTERNAL USE
Debug S32K324 dual-core projects
•Default settings are OK for debugging s32k324.
•The target elf file can also be manually changed.
You can launch this configuration to
debug CM7_0 only
You can launch this configuration to
debug CM7_1 after CM7_0 is already
connected by the debugger
It’s OK to load both cores’ elf
even though you want to debug
only one core.

4EXTERNAL USE
Debug S32K324 dual-core projects
•Default settings are OK for debugging s32k324.
•The target device type can be changed in the
debugger settings page.
If a P&E multilink debugger or
an OpenSDA debugger is
connected to your PC, it can be
seen in this drop-down list.

5EXTERNAL USE
Debug S32K324 dual-core projects
•Default settings are OK for debugging s32k324.
•The target device type can be changed in the
debugger settings page.

6EXTERNAL USE
Debug S32K324 dual-core projects –launch debug
process
Must select a Launch Group to start the dual-core download and debug. Debug settings for core0
Debug settings for core1
This launch will start debugging both
core0 and core1.

7EXTERNAL USE
Debug S32K324 Dual-Core project in S32DS with PE
Multilink
Click to debug core0
Click to debug core1
Must select one core to debug.
The other core is in running
status or in pause status
depending on the previous
debug operation.
Run Break(Pause) Terminate(Stop debugging) Disconnect Step into, Step over, Step return, Single instruction step
Restart (can be used as reset and run)
Both cores are enabled in
boot configuration.

8EXTERNAL USE
Debug S32K324 Project when “CM7_1_ENALBE=0”
•Assumption:
−CM7_1 is NOT enabled during boot. Debugger cannot work before it is
launched. CM7_1 is started in CM7_0 application code.
•Use the same Debug Configuration
as debugging “CM7_1_ENABLE=1”.
•Procedure:
−Download CM7_0 elf and CM7_1 elf
into the flash with Group Launch

9EXTERNAL USE
Debug S32K324 Dual-Core project when
CM7_1_ENALBE=0
Core1 is not started at
this moment, you can’t
debug Core1.