Oase ProMax MudDrain 7000 User manual

ProMax MudDrain 7000 |11000 |14000

2 ProMax MudDrain 7000/11000/14000
A
POX0008
B
POX0013
C D
POX0010 POX0011


3
E
POX0009

10 ProMax MudDrain 7000/11000/14000
Translation of the original Operating
Instructions
INFORMATION ABOUT THIS
OPERATING MANUAL
Welcome to OASE Living Water. You
made a good choice with the purchase of
this product ProMax MudDrain
7000/11000/14000.
Prior to commissioning the unit, please
read the instructions of use carefully and
fully familiarise yourself with the unit. En-
sure that all work on and with this unit is
only carried out in accordance with these
instructions.
Adhere to the safety information for the
correct and safe use of the unit.
Keep these instructions in a safe place!
Please also hand over the instructions
when passing the unit on to a new owner.
Symbols used in these instructions
Warnings
The warning information is categorised by
signal words, which indicate the extent of
the hazard.
WARNING
Indicates a possibly hazardous situa-
tion.
Non-observance may lead to death or
serious injuries.
NOTE
Indicates information intended to give the
user a better understanding.
Additional information
A Reference to a figure, e.g. Fig. A.
Reference to another section.
PRODUCT DESCRIPTION
Overview

A
ProMax Mud Drain
7000/11000/14000
1 Handle, adjustable
2 Pump base
3 Float switch
4 Connection, pressure side, G1½
5 Power connection cable
6 Stepped hose adapter
Intended use
ProMax MudDrain 7000/11000/14000, re-
ferred to in the following as "unit", may
only be used as specified in the following:
For pumping clear water or rain water.
For pumping dirty water and max.
30 mm large particles.
For irrigating and watering.
For transferring water from and draining
basins such as swimming pools.
Extraction of water from a well.
– Only for irrigation and watering pur-
poses!
For pumping the water out of water
butts/rain barrels or cisterns.
Operation under observance of the
technical data.
Possible incorrect use
The following restrictions apply to the unit:
Not suitable for salt water.
Not suitable for drinking water.
Do not use for long-term operation (e.g.
continuous recirculation of the water in
a pond).
Do not use for commercial or industrial
purposes.
Do not use in conjunction with chemi-
cals, foodstuff, easily flammable or ex-
plosive substances.
Do not connect to the drinking water
supply.

DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
11
SAFETY INFORMATION
This unit can be used by chil-
dren aged 8 and above and by
persons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge if they are super-
vised or have been instructed
on how to use the unit in a safe
way and they understand the
hazards involved.
Do not allow children to play
with the unit.
Only allow children to carry out
cleaning and user maintenance
under supervision.
Electrical connection
Only connect the unit if the electrical
data of the unit and the power supply
coincide. The unit data is to be found on
the unit type plate, on the packaging or
in this manual.
Ensure that the unit is fused for a rated
fault current of max. 30 mA by means of
a fault current protection device.
Extension cables and power distributors
(e.g. outlet strips) must be suitable for
outdoor use (splash-proof).
Protect the plug connections from mois-
ture.
Only plug the unit into a correctly fitted
socket.
Safe operation
Dangerous electrical voltage. Possible
death or severe injury from electrocu-
tion! Before reaching into the water, al-
ways switch off and disconnect (isolate)
all units located in the water with a volt-
age of >12 V AC or >30 V DC and se-
cure them from being switched on
again.
Only operate the unit if no persons are
in the water.
Never operate the unit if either the elec-
trical cables or the housing are defec-
tive!
Do not carry or pull the unit by its elec-
trical cable.
Route cables/hoses such that they are
protected from damage and do not pre-
sent a tripping hazard.
Only open the unit housing or its at-
tendant components, when this is ex-
plicitly required in the operating instruc-
tions.
Only carry out work on the unit that is
described in this manual. If problems
cannot be overcome, please contact an
authorised customer service point or,
when in doubt, the manufacturer.
Only use original spare parts and acces-
sories for the unit.
Never carry out technical modifications
to the unit.
Power connection cables cannot be re-
placed. If a cable is damaged, dispose
of the respective unit or components.

12 ProMax MudDrain 7000/11000/14000
INSTALLATION AND CONNECTION
Connecting the pressure hose
An optimum flow rate is achieved with a
hose inside diameter of 38 mm (1½").
How to proceed:
B
1.Adapt the stepped hose adapter to the
hose diameter
2.Screw the stepped hose adapter onto
the connection on the pressure side.
3.Connect the pressure hose to the
stepped hose adapter.
– Secure the pressure hose with a
hose clip.
Automatic mode
When the water level rises, it lifts the float
switch until the switch-on point is reached
and the pump switches on.
When the water level drops, the float
switch lowers until the switch-off point is
reached and the pump switches off.
C
Push the float switch cable into the ca-
ble clip.
– The shorter the cable between the
float switch and the cable clip, the
lower the switch-on point and the
higher the switch-off point.
NOTE
To ensure faultless function, ensure that
the length of cable between the float
switch and the cable clip measures at
least 10 cm.
NOTE
The minimum residual water height is
only reached in manual mode.
Manual mode
The pump remains permanently switched
on if the float switch is set vertically and
the cable points downward.
NOTE
The pump can run dry in manual mode.
Switch off the pump when the minimum
water level is reached.
Running the pump dry increases wear.
D
Move the handle into the horizontal po-
sition and push the cable directly at the
transition to the float switch into the ca-
ble clip such that the float switch is in a
vertical position.
Installing the pump
H
Install the pump in a horizontal and sta-
ble position in the water.
If it needs to be lowered into a well or a
shaft, fasten a rope to the handle. Do
not carry the pump by its power connec-
tion cable.
Install the pump such that it does not
take in dirt particles with a size >30 mm,
which would block the intake. Install the
pump in a raised position if necessary.
Ensure that the float switch can always
move freely.

DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
13
OPERATION
WARNING
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
Only connect the pump to the power
supply when there are no persons in or
reaching into the water.
Before stepping into or reaching into
the water, switch off all units located in
the water.
Switching on the unit
Insert the power plug into the socket.
– The pump is ready for operation.
– The pump will start up as soon as
the level of the water reaches the
switch-on height.
Switching off the unit
Disconnect the power plug.
– When the pump is switched off, re-
sidual water in the hose may flow
back and out of the pump intake.
NOTE
Do not use the unit for long-term opera-
tion. Otherwise this will impair the operat-
ing life of the unit accordingly.
NOTE
Rinse the pump with clean water after
use.
REMEDY OF FAULTS
Malfunction Cause Remedy
Pump does not start. Power supply interrupted Check the fuse and electri-
cal plug connections.
Pump switches off after a
short running period.
Overload protection has
switched the pump off due
to overheating.
Clean the intake and
pressure hose.
Allow the pump to cool
down.
The pump is running but is
not delivering, or the deliv-
ered quantity is insufficient
Pressure hose kinked Route the pressure hose
without kinks
Check the outlet and
clean if necessary
Intake blocked Clean the intake
Air in the pressure hose Expel the air from the
pressure hose.
If applicable:
Non-return valve incorrectly
fitted in the pressure hose
or clogged
Correctly fit the non-re-
turn valve.
Clean the non-return
valve.
Impeller defective or worn Contact OASE
The impeller may only be
replaced by the OASE
Service.

14 ProMax MudDrain 7000/11000/14000
MAINTENANCE AND CLEANING
WARNING
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
Before reaching into the water, switch
off the mains voltage of all units in the
water.
Isolate the unit (disconnect from the
power supply) before carrying out any
work on it.
NOTE
Recommendation on regular cleaning:
Clean the unit as required but at least
twice per year.
Do not use aggressive cleaning agents
or chemical solutions as they could at-
tack the housing or impair the function
of the unit.
Recommended cleaning agent for re-
moving stubborn limescale deposits:
– Pump cleaning agent PumpClean
from OASE.
– Vinegar- and chlorine-free household
cleaning agent.
After cleaning, thoroughly rinse all parts
in clean water.
WEAR PARTS
Wear parts are excluded from the war-
ranty.
The following components are wear parts
and may only be replaced by the OASE
Service.
Impeller
STORAGE/OVER-WINTERING
The unit is not frost-proof and has to be
removed and put into storage if minus
temperatures are expected.
How to correctly store the unit:
Drain the unit as far as possible, clean
thoroughly and check for damage.
Empty all hoses, pipes and connections
as far as possible.
Thoroughly clean the unit, check it for
damage and replace any damaged
parts.
Store the unit in a dry and frost-free
place.
Do not immerse plugs in water.
DISPOSAL
Do not dispose of this unit with domestic
waste! For disposal purposes, please use
the return system provided. Render the
unit unusable beforehand by cutting the
cables.

DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
15
TECHNICAL DATA
ProMax MudDrain 7000 11000 14000
Rated voltage V AC 230 230 230
Rated frequency Hz 50 50 50
Rated power W 325 625 950
Protection type IP68 IP68 IP68
Connection, pressure side – G1½ G1½ G1½
Minimum switch-on height / maximum
switch-off height
mm 500/250 530/270 530/270
Maximum switch-on height / minimum
switch-off height
mm 670/120 700/100 700/100
Flow rate max. l/h 7500 11500 14500
Head height max. m 5 7 11
Immersion depth max. m 7 7 7
Particle size max. mm 30 30 30
Power connection
cable
Length m 10 10 10
Dimensions Length mm 193 193 193
Width mm 247 247 247
Height mm 395 422 422
Weight kg 4.8 6.4 7.7

POX0039