OHAUS Explorer E1F110 User manual

Ohaus Explorer
Manufacturer: Ohaus
Product Range: Explorer
Model Tested: E1F110
Capacity - 6100g
Readability - 0.1g
Note:
The Explorer normally comes with an RS232 serial interface fitted as standard, please check with your balance supplier
that this is the case.
Setting up the balance:
• Getting into RS232 Mode
Turn the unit on.
Press the “Setup” button.
Press the “right” button until “RS232” is displayed then press the “Enter” button.
• Setting the Baud rate to 1200.
“BAUD” should now be displayed, press the “Enter” button.
Press the up or down buttons until “1200” is displayed then press the “Enter” button.
• Setting the Parity to none.
“PARITY” should now be displayed, press the “Enter” button.
Press the up or down buttons until “nonE” is displayed then press the “Enter” button.
• Setting the Data to 7 bits.
“DATA” should now be displayed, press the “Enter” button.
Press the up or down buttons until “7” is displayed then press the “Enter” button.
• Setting the Stop bits to 2.
“STOP” should now be displayed, press the “Enter” button.
Press the up or down buttons until “2” is displayed then press the “Enter” button.
• Setting Lock to Off.
“LOCK” should now be displayed, press the “Enter” button.
Press the up or down buttons until “OFF” is displayed then press the “Enter” button.
• Returning to normal operation.
“EXIT” should now be displayed, press the “Enter” button.
Serial Balance Adapter Data Sheet OH-2
© DCP Microdevelopments Ltd www.dcpmicro.com [email protected] 12/12/00

Setting up the balance (continued):
• Getting into Print setup mode.
Press the “Setup” button.
Press the “right” button until “PRINT” is displayed then press the “Enter” button.
• Setting the balance to autoprint.
“AUTOPRT” should now be displayed, press the “Enter” button.
Press the up or down buttons until “CONT” is displayed then press the “Enter” button.
• Returning to normal operation.
Press the left or right buttons until “Exit” is displayed, press the “Enter” button.
The balance is now set up to work with the LogIT Serial Balance Adapter - See Connecting the Balance for details of the
lead required to connect the balance to the LogIT Adapter.
Connecting the balance:
A cable must be made to connect the balance serial port to the LogIT Serial Adapter using the wiring information below.
Explorer RS232 port, 9 way D Socket Balance Adapter, 9 Way D Socket
pin 2 pin 2
pin 5
pin 6
pin 7 pin 5
Note: These connection instructions are designed for use with the 9 pin boxed version of the LogIT Serial Balance
Adapter. If using the original 25 pin lead type connection you need to use adapter pin 3 instead of pin 2 (data out) and
adapter pin 7 instead of pin 5 (ground).
Serial Balance Adapter Data Sheet OH-2
© DCP Microdevelopments Ltd www.dcpmicro.com [email protected] 12/12/00
Connect balance pin 5 to pin 6 to bypass handshaking