Oki B6250 Series User manual

Copyright © 2009 Curtis Consulting Limited
OKI
OKI B6250 Extended Feed Tray
Installation Manual
Philips Head Screwdriver Required

Copyright © 2009 Curtis Consulting Limited
OKI
Remove the screws shown in red from the paper
tray. You should end up with 10 screws of the same
size.
lgftb6250.jpg

Copyright © 2009 Curtis Consulting Limited
OKI
Slide the clips shown in red to the unlocked
position and extend the tray. The clips will
automatically revert back to the locked position when
fully extended.

Copyright © 2009 Curtis Consulting Limited
OKI
To insert the custom tray the default extendable
tray needs to be removed. To do this the plastic at
each side has to be carefully bent away from the
holding pegs; these are marked by red circles.

Copyright © 2009 Curtis Consulting Limited
OKI
The top layer should come away when eased off
the pegs, make sure the grey locking clips do not fall
out as they can be quite difficult to re-insert.
The standard tray can now be removed.

Copyright © 2009 Curtis Consulting Limited
OKI
Make sure the clips are in the locked position
and hold the tray vertically on the surface. Then insert
the custom tray until it is resting on the clips. You may
need to lift the clips to allow the tray to drop in.
Resting on the clips
Reinsert the 10 screws into the tray. If you’re having
trouble refer back to the guide pictures.

Copyright © 2009 Curtis Consulting Limited
OKI
Now slide the clips into the unlocked position; the tray
should drop further, then relock the clips. The tray
should now be secure.
Simply insert the paper tray into the printer as
normal, the extended feed tray is now complete.

Copyright © 2009 Curtis Consulting Limited
OKI