Okolab UNO-T-H-PREMIXED User manual

Version............ 1.1
December 2016
www.oko-lab.com
QUICK INSTALLATION & USER GUIDE
UNO-T-H-PREMIXED

x1 x1 x1 x1
x1 x1x1
x1 x1x1 x1
Package Content
Gas tubing
1
T
o CO
2
supply
To Chamber
1
Heated Tube
3
2
Humidifier
Humidifier
Gas tubing
Heating devices
Setting up UNO
1
2
3
4
~3’
~3’
~4’
~6’
Summary

1
• Press ‘Settings’
• Press ‘Chamber & Insert’
• Select chamber and insert in use, then
press ‘OK’
2
NOTE: ‘Chamber’ control mode uses sensors embedded in the chamber body. Accuracy +/- 0.3°C from set-point, if
room T remains within +/- 0.3°C. ‘Sample’ control mode requires inserting the provided temperature sensor in a
reference well. Accuracy +/- 0.1°C regardless of room temperature.
• Press ‘Settings’
• Press ‘Control Mode’
• Select the Control Mode and press
‘Save’
Selection of Chamber & Insert
Selection of Control Mode
Setting up UNO
Setting up UNO
5
To Humidifier
CO2pressure setup
Set at 1 bar (15 psi)
Set at 2 bar (30 psi)
3
• Check the ‘humidity control enabled’
box
• Input room temperature
• Press ‘Save’
4
• Press ‘Enabled’
• Press ‘OK’
NOTE: it is important to enter the right room
temperature. You may check it with the help
of the ne gauge thermocouple (green wire)
Humidity control set-up
Objective Heater (optional)
Setting up UNO
1
2
3





www.oko-lab.com
QUICK INSTALLATION & USER GUIDE
Temperature range From 3°C above ambient to 60°C
Temperature accuracy
±
±0.1°C in sample feedback mode
±0.3°C in chamber feedback mode, if room temperature remains within 1°C
85% ca.
Controller dimensions 103 x 130 x 59 mm
Humidity efficiency