Olg Og_axesd1275_w User manual

AXIS ELECTRIC HEIGHT ADJUSTABLE DESK

Installation Guide (For mm wide desk)

Safety and Warnings

• This table complies with the prescribed safety regulations. Inappropriate

use may cause damage to persons and table.

• Please read the operation manual prior to start using the table. It provides

you with important information about safety, use, installation and

maintenance of the table, and

thus protecting you and your children and avoiding damage on the table.

• Please guard this operation manual and pass it on to any future owner!

Usage

The electromotive, height-adjustable tables are designed for workstations in dry

work environments only. The table height is inﬁnitely adjustable, so that it can be

set to the most ergonomically suitable working level.

They have not been designed for other purposes than those included in this

manual, e.g. they are not to be used in areas of high humidity or dampness, nor

for lifting people.

Any other use is at one’s own risk!

Do not crawl, lie or move around under the table frame, and do not sit or

stand on the table frame.

CHILDREN should only use the table when supervised by adults.

Liability: The manufacturer accepts under no circumstances warranty claims or

liability claims for

damages arising from improper use or handling of the table frame other than that

described in this operation manual.

Set-up and Installation

When the table has been assembled (see assembly instructions on page 3-4)

the adjustable feet are installed so that the table is level and does not shift.

Then the table is connected to the 110-230 VAC outlet and the table is ready

for use.

Make sure that no cables can get jammed.

Place the table in a safe distance from window frames, radiators, furniture etc. so

that people do not get stuck.

Do not place any objects above 55 cm underneath the table.

When moving the table after it has been assembled, the table top needs to be

removed. The table CANNOT be lifted by the tabletop.

Operation

AXISELECTRIC HEIGHT ADJUSTABLE DESK

Installation Guide (For mm wide desk)

UP/DOWN OPERATION:

BOTH buttons must be pressed

SIMULTANEOUSLY either right or

left.

Maintenance and Defects

The table does not require any maintenance by usage as described in the above

section.

The table is only to be maintained with a wrung cloth.

In the event of the occurrence of jarring sounds during operation, STOP using the

table and please contact the dealer.

Technical Data

Frame, Materials

and Weights:

Steel, silver or white - weight metal frame kg

Width: -mm

Depth: -mm

Height: -mm

V (Speed): mm/sec

FMax=Max. load on

worksurface:

kg

Operation: Rocker switches

Voltage: - VAC/Hz or - VAC/Hz

Consumption:  Watt; Standby: Max . Watt

Parts

AXIS ELECTRIC HEIGHT ADJUSTABLE DESK

Installation Guide (For mm wide desk)

STEP 4: Once the gear rail is fully extended, tighten the 2 small grub screws on the rail to secure

the rails length.

STEP 3: Slide the gear rail onto the opposite leg to the motor, then fully extend the rail until it

meets the drive shaft on the motor.

STEP 2: Slide modesty panel into position on each leg, tighten cam to lock in place. Use a soft

headed hammer as necessary to ﬁt the plastic cover caps to each cam.

STEP 1: Screw 2 modesty panel pins into each leg.

AXIS ELECTRIC HEIGHT ADJUSTABLE DESK

Installation Guide (For mm wide desk)

STEP 8: Connect the power supply to the controls. Test operation.STEP 7: Secure the power supply and controls in the locations pictured below. Ensure the

controls are located near the front edge of the worksurface.

STEP 6: Secure the worksurface to each leg using the provided screws.STEP 5: Place worktop on a clean, ﬂat surface and centre the frame as per dimensions provided.

AXIS ELECTRIC HEIGHT ADJUSTABLE DESK

Installation Guide (For mm wide desk)

mmmm

mm