Olympus InstaClear User manual

INSTACLEAR
Setup and Operation Quick Reference Guide
This setup guide is only a summary of the InstaClear Instructions for Use (IFU). For detailed operating
instructions, be sure to follow the InstaClear IFU that was included with your device
when purchased.
15460

1 | Setup
2 | Power-Cord Attachment
3 | Power On
Setup with Suction Module Setup without Suction Module
Ensure the console is properly assembled onto an IV pole before use. To reduce the risk of tipping and possible equipment
damage, always follow the recommended height guidelines shown above.
The power cord needs to be attached to the back of the unit
and to a grounded wall outlet.
Turn the InstaClear system on by pressing the power button
at the lower left corner on the front of the console. The
power switch will illuminate.
15461
1.57 m
maximum
1.3 m
maximum
Attach power cord
Turn the
Console On
15455 1545715448

7 | Attach Irrigation
With the pump lever open, position the blue portion of the tube set across the tube guide. Thread the clear portion of the
tube set through the pump and close the pump lever. Remove the IV-spike cover and insert the IV spike into the IV bag.
4 | Connect Foot Pedal
5 | Assemble Endoscope in Sheath
Align the foot-pedal plug and foot-pedal socket (on the rear
of the console) and insert the plug fully into the socket.
Grasp the sheath by the hub and slide it over the end of the scope, hub end first, until it stops at the distal end (a slight gap
is appropriate between the sheath hub and the light post).
Thread the Luer lock connector of the tube set onto the Luer
lock port of the sheath.
6 | Attach Sheath to Tube Set
Gap
Tip-Angle Label Hub
Luer Lock Light Post
15458
15447
15449
15452 15453

Specifications, design, and accessories are subject to change without any notice or obligation on the part of the manufacturer.
Postbox 10 49 08, 20034 Hamburg, Germany
Wendenstrasse 14–18, 20097 Hamburg, Germany
Phone: [phone], Fax: [phone]
www.olympus-europa.com
E049xxxxEN ∙ x00 ∙ 05/16 ∙ OEKG ∙ ED
8 | Attach Suction
While pressing the button on the pinch valve, insert the blue tubing through the slot of the pinch valve and around the strain-
relief hook below. Release the button on the pinch valve. Connect the suction end of the tube set to the vacuum canister.
For best results, use a dedicated vacuum source such as the DIEGO ELITE suction module. If using the DIEGO ELITE
suction module, insert the filter end of the suction tubing (EGTS102SF) into the suction connection on the front of the
suction module. Attach the blue suction connector at the other end of the suction tubing to the suction canister.
9 | Prime
10 | Disassembly
Press and hold down the foot pedal to perform the priming
sequence. When fluid can be seen flowing out of the distal
tip of the sheath, the priming sequence is complete.
Unhook the tube set from the sheath. Slide the sheath distally off the endoscope to disassemble and dispose of the sheath.
Press the pinch-valve button on the InstaClear console and remove the blue tubing from the pinch valve. Open the pump
lever and remove the tubing from the pump. Pull the IV spike from the IV bag, being careful not to spill any remaining fluid,
and dispose of the tube set. Press the power button to turn off the system. Disconnect the power cord from the wall outlet.
Clean and disinfect the console and foot pedal according to the IFU.
Foot pedal
Strain-Relief Hook
15454 1545615450