Olympus K-401 User manual

GuideSheath Kit 2 Quick Reference Guide
Single Use Guide Sheath Kit
K-401/402/403/404
1 Types of Stoppers
Below are important steps for handling the GuideSheath Kit 2. For detailed operating instructions, be sure to
follow the instruction manual included in the device package.
The GuideSheath Kit 2 comes with two types of stoppers – one for an ultrasonic probe and one for EndoTherapy
accessories.
2 Operation of ET/US Stoppers
<Preparation of US Stopper>
Insert the ultrasonic probe into the guide sheath’s
accessory port so that the probe tip protrudes
slightly from the guide sheath tip. Attach the US
stopper to the ultrasonic probe by inserting the
probe to the end of the slit.
Push the US stopper
connection portion
into the guide sheath’s
accessory port to
secure it.
Adjust the position of the
US stopper so that the
probe tip protrudes slightly
from the guide sheath tip.
Remove the US stopper
from the guide sheath’s
accessory port while
attaching the US stopper
to the ultrasonic probe.
1
2 3
Model K-401 K-402 K-403 K-404
Compatible channel diameter 2.0 mm or more 2.8 mm or more
ET stopper 4 pieces
(White)
3 pieces
(White)
4 pieces
(3: Gray / 1: White)
3 pieces
(2: Gray / 1: White)
US stopper 1 piece
(Gray)
1 piece
(Gray)
Note:
Make sure the ultrasonic probe
reaches the end of the slit on
the stopper. US stopper
Accessory port

<Preparation of ET Stopper>
Insert the EndoTherapy device into the guide sheath’s
accessory port so that the device tip protrudes slightly
from the guide sheath tip. Attach the ET stopper to
the EndoTherapy device by inserting the EndoTherapy
device to the end of the slit.
Adjust the position of the ET stopper so that the tip of each device protrudes from the guide sheath tip as
shown below:
3 Attachment of Stopper to the Guide Sheath
Attach the ET stopper
to the guide sheath with
the ultrasonic probe or
EndoTherapy device
inside.
1Insert the guide sheath
with stopper into the
endoscope. When
it reaches the target
position, move the
stopper attached to
the guide sheath until it
makes contact with the
biopsy valve.
2
Notes · Do not insert the guide sheath into the endoscope when it is not combined with any EndoTherapy accessory or
ultrasonic probe. Doing so could result in bending or breaking the guide sheath.
· When inserting the guide sheath, hold it close to the biopsy valve and keep it as straight as possible, then insert it
gently into the endoscope.
Tips
Caution
If the endoscope's insertion section near the control
section is bended, it may be difficult to advance the
EndoTherapy device into the guide sheath smoothly.
Make sure to keep the insertion section near the
control section of the endoscope as straight as
possible.
Guiding device Biopsy forceps Cytology brush Aspiration needle
Bended
N8602374-122021
Straight
Note:
Make sure the EndoTherapy device
reaches the end of the slit on the
stopper. ET stopper
Postbox 10 49 08, 20034 Hamburg, Germany
Wendenstrasse 14-18, 20097 Hamburg, Germany
Phone: [phone], Fax: [phone]
www.olympus-europa.com
As medical knowledge is constantly growing, technical modifications or changes of the product design, product specifications, accessories and service offerings may be required.