Omega Altise AP360R User manual

1
AP360R
SLIM PEDISTAL FAN

2
SAFTEY INSTRUCTIONS
1. Read all instructions carefully and keep this manual for future reference.
2. To avoid electric shock, do not place the cord, the plug or the appliance in water or other
liquids.
3. Close supervision is necessary when the appliance is eing used y or near children.
4. Disconnect the fan when not in use and efore cleaning.
5. Do not place the fan on unsteady or uneven surfaces.
6. Do not insert fingers or other o jects into the fan during operation
7. Do not spray any products such as ug spray into the fan.
8. The appliance is for household use only. Do not use outdoors or for any commercial or industrial
purpose.
9. This appliance is not intended for use y persons (including children) with reduced physical,
sensory or mental capa ilities, or lack of experience and knowledge, unless they have een
given supervision or instruction concerning use of the appliance y a person responsi le for
their safety.
10. Children should e supervised to ensure that they do not play with the appliance.
11. Always disconnect the mains power, efore any maintenance.
12. If the power cord is damaged, it must e replaced y the manufacturer, its service agent or a
similar qualified person in order to avoid a hazard.
13. Please ensure that the fan is switched off from the supply mains efore removing the guard.
14. Do not use the appliance for any other purpose than its intended use
15. The unit should e used under the rated voltage and rated frequency indicated.
16. Assem le the fan efore plugging it into the power.

3
Fan Assembly
1. Stand the pole on the ase and fix them tightly y screw.
2. Put the ase and pole on the desk or flat floor, connect the fan head with the pole
tightly fixing with the olt screw.
3. Fix the rear grid with the motor tightly y grid clamping screw.
4. Fit the fan lade on the motor axes, tightly fixing y lade screw.
5. Assem le grid ring and REAR GRID up together. Bring grid ring into position correctly and
tighten on using GRID CLAMPING SCREW. Before switching the device on, make sure the grid
is fixed on tightly.
3
1
2
4
5

4
Fan Operat on
Control panel
1. ON/SPEED mode :
Press ON/SPEED ONCE, the standard fan mode indicator will go on with the device operating at
MEDIUM to LOW speed levels. Press ON/SPEED TWICE for LOW, MEDIUM and HIGH speed selection.
The display indicates the following:
High Middle Low
2. OFF SWITCH:
Press OFF to turn the device off.
3. MODE :
The fan has 3 working modes: press MODE utton, it will change as following:
normalnaturesleeping, and the display will show the mode type accordingly.
NORMAL: sym ol will show on display. The unit gives a constant fan speed depending on the Speed setting
selected.
NATURAL : Press MODE: the natural ventilation fan mode control light will show .The speed of
wind will e at a HIGH, MEDIUM and LOW, then Circulation mode. (The standard wind only show the
sign )
SLEEP: sym ol will show on display, and the unit enters in a sleep mode and reduces the fan speed
during the course of 30 minutes.
The reduction in fan speed is shown in the ta le elow.
Preset fan speed Fan running time
High Natural High Natural Medium Natural low
0-30min 30-60min continue
Medium Natural MediumNatural Low
0-30min continue
Low Natural Low
continue

5
4. OSCILLATION: + or - Used to control the oscillation angle. Oscillation angle can set
as：30°→60°→90°→135°→180°→360°→off→30°…，and the LCD display will change accordingly.
5. ＜
＜＜
＜ ＞
＞＞
＞ Can used to set the oscillation angle y hand, and the LCD display will change accordingly.
6. TIMER:
Press the TIMER utton , you can set the running time for this fan, Time setting as :
0.5h1h1.5h…8h00.5h, When the indicator shows 0.0, the fan will not swing
7. SWING FUNCTION:
Press SWING once: the fan will swing horizontally with the relative control light
on.
8. REMOTE CONTROL:
Remote control functions are the same as those provided on the fan control panel. When not in use,
store the REMOTE CONTROL carefully. The remote controller could e put up at the ack of the STAND
SHAFT.
Remote Control

6
Omega Altise products are distri uted in
Australia y Shriro Australia Pty Ltd.
Locked Bag 5002, Kingsgrove NSW 2208
Phone: [phone] Fax: [phone]
We : www.omegaaltise.com.au