Omega Altise AP46WA User manual

Instruction
Manual
AP46WA
46cm Pedestal Fan

omega altise
2
Important Safety Instructions
1. Read all instructions.
2. Disconnect the power plug before dismantling, assembling or before cleaning.
3. Avoid touching mobile parts of the fan.
4. Make sure the fan is on a dry and even surface.
5. Never insert fingers, pencils or any other objects through the guards whenever
the power plug is connected, especially while running.
6. The appliance is not intended for use by young children or infirm persons unless
they have been adequately supervised by a responsible person to ensure that
they can use the appliance safely.
7. Young children or infirm persons should be supervised to ensure that they do not
play with the appliance.
8. Do not use the appliance for any other purpose than its intended use.
9. The fan must not be used if the guards are not fastened according to
instructions.
10. When the power cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
11. Do not use your appliance with an extension cord unless it has been checked
and tested by a qualified electrician or electrical supplier.
Read all instructions before using this unit. Keep them for future reference.
Specifications
Model AP46WA Settings 3 speed
Rated Voltage 220-240V / 50Hz Adjustable Height Yes
Watts 60W Oscillation 90°oscillation
Controls Push button Warranty 2 year replacement
Dimensions (cm) 51.5 x 14.5 x 60.5

omega altise
3
Assembly Instructions
Assemble the Base Foot of the Stand Fan and Connect the Stand to the Base
Foot
Put the screw into the hole in the support pole and turn the screw clockwise to clamp
the stand and the support pole.

omega altise
4
Loosen the height adjustment ring and extend the support pole. Initially the support
pole will be held tightly in place. If necessary, use a pair of pliers to grasp the
support pole and pull it into position.
To assemble the safety grille and blade assembly, remove the spinner (by turning it
clockwise), then the locking nut (by turning it anticlockwise) from the motor spindle
Connect the Main Part to the Stand
Step 1: Loosen the height adjustment ring and extend the support pole to your
desired height and then tighten the height adjustment ring.
Step 2: Connect the main part to the support pole and then tighten the locking screw

omega altise
5
Assemble the Fan Blade and Fan Guard Assembly to the Main Part of the fan
Step 1: Unscrew the Blade Nut and Locking Nut
Step 2: Assemble the Fan Guard – back side to the main part of the fan by aligning
the small groove of the fan guard to the plastic pole to fix the position. Screw the lock
nut to the main part of the fan.

omega altise
6
Step 3: Fix the blade into place by tightening the spinner gently in an anticlockwise
direction onto the end of the motor spindle. The spinner is self-tightening
and hence DO NOT FORCE IT.
Step 4 Lift out all locking clips on the Fan Guard – Front side.
Step 5: Place the Fan Guard – front side into position and secure it by clipping the
locking clip over the outer rim. Screw the screws and nut at the bottom of
the fan guards.

omega altise
7
Operating Instructions
Press Button 0 to ensure the fan is in the “Off” mode.
Plug in the power cord
Press Button 1 for Low Speed, 2 for Medium Speed and 3 for High Speed.
Press Button 0 for the “Off” mode
Turn the timer knob to set the operating time.

omega altise
8
Care and Maintenance
1. Always disconnect the cord from the electrical outlet when cleaning your fan.
2. Light accumulated dust may be removed from the fan with a soft cloth or vacuum
cleaner using the dusting brush attachment.
3. Wipe the exterior surfaces of the fan occasionally with a cloth moistened (not
dripping wet) with a mild soap solution. Dry the case thoroughly with a soft dry
cloth before operating the fan.
4. Avoid the use of gasoline, benzine, thinner etc as they may result in damage to
the fan.
5. Store the fan in a clean dry place when not in use.
CAUTION! Do not immerse the fan in water or allow water to drip into
the interior of the fan housing as this could create a fire or electric
shock hazard.
WARNING! Do not attempt to open or repair the fan yourself. Doing so
could void the warranty and cause damage or personal injury.
Omega Altise products are distributed in Australia by Hagemeyer Appliances,
(A Division of Hagemeyer Brands Australia Pty Ltd)
ABN 28 001 375 686
Locked Bag 4013, Kingsgrove NSW 2208
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Web: hagemeyerappliances.com.au