Omron EQUO Series User guide

・To directly connect KM-N1-FLK, KM-N2-FLK and
KM-N3-FLK to ZN-KMX21-□, please purchase a
separately sold dedicated connection cable
ZN9-KMC30-N.
Terminal names may differ depending on the model type.
See below to make communication setting of the KM series.
Unit No.: A consecutive number starting from 1.
To change the starting number (other than 1), other setting is required.
Baud rate: 38400 bps
Data bit length: 7-bit
Stop bit length: 2-bit
Vertical parity: even
D
Recommended SD card: HMC-SD491 (4GB)
HMC-SD291 (2GB)
Power Monitor KM-N1-FLK,KM-N2-FLK,
KM-N3-FLK
For further information, refer to the Instruction Sheet in the package
and a user's manual.
The connected Power Sensor/Monitor units must be turned ON before the Power Sensor Station.
If the order is reversed, the station may not correctly recognize the type names of the Power Sensor/Monitor units,
which may result in power data acquisition failures.
Caution
Recommended SD card: HMC-SD491 (4GB)
HMC-SD291 (2GB)

Installation data is downloaded in a PC from following URL.
When Setup.exe in the installation data is executed, the right screen is indicated.
User’ s Manual is downloaded in a PC from following URL.
http://www.fa.omron.co.jp/products/family/3080/download/manual.html
http://www.fa.omron.co.jp/station-u-e

SEN
E2002 Sensor communications error
SEN
E2003 Sensor registration failed
Communication with the sensor failed. Check the
wiring between the sensor and the main unit.
To cancel the error display, press and hold the
MODE key for 3 seconds or more.
Failed to register the sensor in the initial processing
on startup. Check the wiring between the sensor and
the main unit, and restart the main unit.
If you turn on the power of the main unit before the
sensor starts up, the sensor cannot be properly
registered.