Omron Hn-290t User manual

INSTRUCTION MANUAL

Digital Weight Scale

Model: HN-290T

9301200-8C

IM-HN-290T-03-09-2021

ENGLISH

Table of Contents

Introduction..................................................................................................................................................3

Important Safety Information ...............................................................................................................4

1. Know Your Device.............................................................................................................................6

2. Before Taking a Measurement.....................................................................................................7

3. Take a Measurement......................................................................................................................10

4. Transfer the Data.............................................................................................................................12

5. Delete all Readings and Settings..............................................................................................13

6. Error Messages and Troubleshooting.....................................................................................14

7. Maintenance.....................................................................................................................................16

8. Specications...................................................................................................................................17

9. FCC/IC Statement and Trademarks..........................................................................................18

10. Limited Warranty ........................................................................................................................... 20

11. Guidance and Manufacturer’s Declaration...........................................................................21

Introduction

Intended Use

Thank you for purchasing the OMRON Digital Weight Scale. This product is mainly

designed for general household use. It is intended to measure and display the

weight from 10 kg to 250 kg (22 lb to 550 lb), and intended for providing all data for

doctor's diagnostic purpose or reference.

All data is wirelessly uploaded to your Telehealth's service by Bluetooth®, this will

make your data management more convenient.

Please follow this instruction manual thoroughly for your safety.

Please keep for future reference. For specic information about your own weight,

CONSULT YOUR PHYSICIAN.

Important Safety Information

To assure the correct use of the product, basic safety measures should always be

followed including the warnings and cautions listed in this Instruction Manual.

Warning: Indicates a potentially hazardous situation which, if not

avoided, could result in death or serious injury.

General Usage

Do not begin a weight reduction or exercise program without consulting a

doctor or healthcare provider rst.

Self-diagnosis could damage your health.

Stop using the unit and consult your doctor if you experience skin irritation or

other troubles.

Do not use the scale on slippery surfaces, such as a wet oor.

Keep the scale out of the reach of young children.

Do not jump onto the scale, or hop up and down on the scale.

Do not use this scale when your body and/or feet are wet, such as after

taking a bath.

Do not step on the edge or display area of the scale.

People with disabilities, or who are physically frail, should always be assisted

by another person when using this scale. Use a handrail or so when stepping

on the scale, and make sure not to inuence the measurement.

If battery uid should get in your eyes, immediately rinse with plenty of clean

water. Consult a doctor immediately.

Do not put your ngers into any slot or inside the scale.

Use indoors.

Do not use this scale for purpose other than described in this manual.

Data Transmission

Do not use this product in hospitals, aircrafts or other environments where the

use of radio waves is restricted. Please remove the batteries in this environment.

This product emits radio frequencies (RF) in the 2.4 GHz band, use of this

product in locations where RF is restricted is not recommended. The use of RF

in this product is licensed for use by the FCC/IC, for further information on any

potential restrictions refer to documentation on Bluetooth

usage by the FCC/IC.

Caution: Indicates a potentially hazardous situation which, if not

avoided, may result in minor or moderate injury to the user

or patient or damage to the equipment or other property.

General Usage

Approved for human use only.

Do not share this scale with others, this will inuence your data management.

Clean the scale before use if it has been used by people with a skin disease

on their feet.

Do not place the scale against the wall. May cause injuries and malfunction.

Do not disassemble, repair, or remodel the scale.

Replace worn battery with a new one immediately.

Do not dispose of batteries in re.

If battery uid should get on your skin or clothing, immediately rinse with plenty

of clean water.

Battery Usage

Do not use battery not specied for this scale. Do not insert the battery with

the polarities in the wrong direction.

Use only 4 "AA" alkaline batteries with this device.

Do not use other types of batteries. Do not use new and used batteries together.

Remove the batteries if the device will not be used for three months or more.

General Advice

• Do not place this unit on a cushioned surface such as a carpet or a mat.

• Do not place this unit in highly humid environments, such as a bathroom or

shower room. Protect it from splashing water.

• Do not place this unit near heat sources or below air conditioners, and avoid

exposure to direct sunlight.

• As this unit is a precision instrument, do not drop, vibrate, or apply strong shock.

• Disposal of used batteries should be carried out in accordance with the national

regulations for the disposal of batteries.

• Do not wash the unit with water.

• Do not wipe the unit with benzene, gasoline, paint thinner, alcohol, or other

volatile solvents.

• Do not place this unit where it will be exposed to

chemicals or corrosive vapors.

• Please store this scale on a level surface.

• Do not store any objects on the scale.

Important Safety Information

1. Know Your Device

Contents:

• Digital Weight Scale • 4 "AA" Alkaline Batteries • Instruction Manual

• Quick Start Guide

Unit:

Display

Metric switch

Battery cover

Reset button

(Do not press it without contacting

your Telehealth service provider.)

Display:

SYNC

symbol Battery symbol

(low/depleted)

Connection

symbol

Display symbols:

SYNC Symbol ( )

The SYNC symbol ( ) is displayed if device is not connected to Telehealth

service receiver or when data is not transmitted successfully. Please see

"Connecting failure. The data is not being transmitted." in section 6.2.

Feet (×4)

2. Before Taking a Measurement

2.1 Wireless Function

Before use, thoroughly read the instruction manual included with the Telehealth

service receiver (in some cases, receiver maybe your smart phone) being used

with this digital weight scale for instruction about your scale to Telehealth service

receiver, and receiver transmission range. It will be necessary for the digital weight

scale to be within the receiver’s transmission range to successfully transfer data.

This Omron digital weight scale is designed to connect to specic Bluetooth®

receivers, and is not guaranteed to connect to all Bluetooth®compatible devices

and Telehealth service receiver. "Omron Healthcare, Inc. shall not be liable for

loss of use or any other special, incidental, consequential or indirect costs,

expenses or damages due to improper usage of this scale."

2.2 Select the weight metric "kg" or "lb" when the power

is off.

2.3 Battery Installation

1. Remove the battery cover on the back of the unit.

2. Insert 4 "AA" batteries as indicated in the

battery compartment.

2. Before Taking a Measurement

3. Close the battery cover.

Notes:

• When the depleted battery symbol ( ) appears, replace all four batteries with new

ones. Items stored in memory are retained even if the batteries are removed.

• Disposal of used batteries should be carried out in accordance with the national

regulations for the disposal of batteries.

2.4 Connect the device to the Telehealth service receiver

As soon as you insert the batteries, the connection symbol ( ) and "P" symbol

will blink on the display.

When the display shown above does not appear, see "Connecting failure."

in section 6.2 rst.

To retry connecting the Telehealth service receiver, remove batteries and

insert them again. Then start with section 2.4 again.

Note:

• If your Telehealth service receiver asks for PIN code, enter 6 digits of PIN code from the

label on the bottom of the device to complete.

2.5 Confirm if the device is successfully connected.

When the unit is connected successfully to the Telehealth service receiver,

the connection symbol ( ) and "OK" symbol will appear on the display.

Wait 10 seconds until the power is o󰀨.

When "Err" appears, see "Connecting failure" in

section 6.2 for more detail.

2. Before Taking a Measurement

3. Take a Measurement

3.1 Place the unit on a hard and at surface. Calibrate

the unit by stepping on (turning on) and immediately

step o󰀨. Calibration is completed till "0.0 kg/lb"

is displayed.

Notes:

• Do not place the unit on a

cushioned surface such as a

carpet or a mat.

• Do the calibration when the display is OFF.

• No further calibration is necessary unless the scale is moved to new location

or battery change.

3. Take a Measurement

3.2 Step onto the unit and take the measurement.

1. Step onto the unit.

Notes:

• Remain still during the measurement.

• Try to measure your weight at the same

time each day for consistency.

2. When the unit beeps twice, the measurement is completed.

Beep

4. Transfer the Data

As soon as the measurement is completed, the data will be transferred automatically

as below.

Transferring the data. The transfer is completed.

The unit will automatically

turn o󰀨 after 10 seconds

without any operations.

Notes:

• When the connection symbol ( ) does not appear, refer the "The data is not

being transmitted." in section 6.2 for more detail.

• If SYNC symbol ( ) is displayed, it means 1 or more readings have stored.

30 readings could be stored at most. If the memory is full, the unit will delete the

oldest reading.

5. Delete all Readings and Settings

You can delete all readings and settings which have not been transferred after you

conrmed this with your Telehealth service provider.

Contact your Telehealth service provider for detail steps.

When your Telehealth service provider mentions to press the reset button, use a

small stick to press it.

Note:

Do not press the reset button without contacting your Telehealth service provider.

This may inuence your data management.

6. Error Messages and Troubleshooting

6.1 Error Messages

Cause Solution

Connecting failure.

The data is not being

transmitted.

Refer "Connecting failure.

The data is not being transmitted."

in section 6.2.

Batteries are low.

Recommend to replace the batteries

with new ones ahead of time.

Refer to Section 2.3.

Batteries are depleted. Replace the four batteries.

Refer to Section 2.3.

Movement during

measurement.

Do not move until measurement is

completed.

Device error. Contact your Telehealth service

provider.

Your body weight is more

than 250 kg (550 lb).

Weight range: 10-250 kg

(22-550 lb).

Misalignment during

auto-calibration. Repeat the measurement.

Connecting failure. Refer to Section 6.2.

6.2 Troubleshooting

Problem Cause Correction

Even if you step onto

the unit, nothing is

displayed.

No batteries are inserted. Insert the batteries.

The batteries are inserted

in the wrong direction.

Insert the batteries in the

correct direction.

The batteries are worn

out.

Replace all four batteries

with new ones.

Connecting failure.

The data is not

being transmitted.

The receiving device is

too far away from the

device.

After checking that

there are no sources of

interference nearby, move

the receiving device to a

distance within 5 m (16 ft.)

of the scale. Then try to

connect again*.

The application on the

receiver or destination

device is not ready.

Check the application then

try to connect again*. If the

"Err" is on the screen after

checking the application,

contact your Telehealth

service provider.

*To retry connecting the Telehealth service receiver, remove batteries and insert

them again. Then start with section 2.4 again.

Error Messages and Troubleshooting

7. Maintenance

To protect the unit from damage, please observe the following:

• Use a soft dry cloth, or a soft cloth moistened with neutral soap to clean the unit.

• Store the unit and the components in a clean, safe location.

• Do not use any abrasive or volatile cleaners, gasoline, thinners or similar solvents

to clean the device.

• Do not clean the unit and any components by immersing them in water.

• Changes or modication not approved by the manufacturer will void the user

warranty. Do not disassemble or attempt to repair the unit or components.

8. Speciﬁcations

Product description Digital Weight Scale

Model HN-290T

Display 10 to 100 kg with an increment of 0.1 kg

(22 to 220 lb with an increment of 0.2 lb)

100 to 250 kg with an increment of 0.2 kg

(220 to 550 lb with an increment of 0.5 lb)

Weight Accuracy 10 kg to 40 kg: ± 0.4 kg

(22 lb to 88 lb: ± 0.88 lb)

40 kg to 250 kg: ± 1%

(88 lb to 550 lb: ± 1%)

IP Classication IP21

Power Supply 4 "AA" alkaline batteries (LR6)

Battery Life Approximately 1 year (when used once per day)

Operating Temperature/

Humidity

+10°C to +40°C (+50°F to +104°F), 15% to 90% RH

Storage Temperature/

Humidity/Air Pressure

-20°C to +60°C (-4°F to +140°F), 10% to 95%

RH, 860 hPa to 1060 hPa

Weight Approximately 3.5 kg (7.7 lb) including batteries

External Dimensions Approximately 41 (H) × 415 (W) × 360 (D) mm

1 3/5" (H) × 16 1/3" (W) × 14 1/5" (D)

Contents Digital Weight Scale, 4 "AA" alkaline batteries,

instruction manual, and quick start guide

Applied Part = Type BF

Note: Subject to technical modication without prior notice.

Need for the user to consult the instruction manual.

FCC CAUTION

Changes or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment o󰀨 and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit di󰀨erent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This transmitter must not be co-located or operated in conjunction with any other

antenna or transmitter.

This equipment complies with FCC/IC radiation exposure limits set forth for an

uncontrolled environment and meets the FCC radio frequency (RF) Exposure

Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules.

This equipment has very low levels of RF energy that are deemed to comply without

testing of specic absorption ratio (SAR).

This device complies with Part 15 of the FCC Rules and Industry Canada license-

exempt RSS standard(s). Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modications made to this equipment not expressly approved by

NeuroSky Inc. may void the FCC authorization to operate this equipment.

9. FCC/IC Statement and Trademarks