Ooni Koda 16 User manual

Ooni Koda 16
Feet Replacement
Manual

Contact support.ooni.com if you have any questions about assembly.
Register your oven at ooni.com/warranty for a free warranty extension.
Hello awesome Ooni Koda 16 owner!
It took Finlay, Pip and Kevin at Ooni HQ ages to make this guide to help you get the best
results from Ooni Koda 16. We’ve poured in all of our experience of pizza and Ooni ovens,
our technical knowledge and a whole lotta love to make sure this guide is as simple to
follow as possible.
Our only goal is to make sure you make awesome pizza with no fuss. So please, read it
from cover to cover before you start and follow the instructions carefully as you work
through your maintenance or service.
Happy ooni-ing!
Pip - Designer & pepperoni lover
Finlay - Engineer & margherita fanatic
Kevin - Ooni Experience & happy as long as it’s hot, fresh and made in an Ooni oven

1
Before you begin
Tips
• Switch off Ooni Koda 16 and disconnect from any gas source
• Ensure that Ooni Koda 16 is completely cool
• Work on a clear surface in a low-dust workspace
• Gather the tools required
• Remove the stone baking board from Ooni Koda 16
• Make sure you have at least 20 minutes to complete the conversion.
• Check out our video guide on YouTube to help you.
• You will need to supply your own Phillips head screwdriver.
• Do NOT use electric drills as these can strip bolts
• Have a compartmentalised box to store bolts and screws during assembly.
This will help with reassembly
In this kit
• 1x Foot pad
• 1x Foot
• 3x Screws

2
Step by step
Remove the stone baking board from
Ooni Koda 16.
Collapse Ooni Koda 16’s legs and then
gently lay Ooni Koda 16 upside-down on
a soft surface to prevent any scratches or
damage to the top shell.
Using a Phillips head screwdriver, turn
counter-clockwise to remove the screws
on top of the foot and on the leg.
You will need:
Phillips head screwdriver
Remove screws

3
Remove the top of the foot.
Slide the other part of the foot down the
leg and out.
Replace with the new foot.
Remove and replace feet
1
2

4
Step by step
Using a Phillips head screwdriver, turn
clockwise to secure the screws on the
legs.
Using a Phillips head screwdriver, turn
clockwise to secure the screw on top of
the foot.
You will need:
Phillips head screwdriver
Remove screws

ooni.com
© 2020 Ooni
Ooni is a registered trademark of
Ooni Limited. All rights reserved v1.0