opti-solar SNMP Manager User manual

SNMP Manager Quick Guide
V. 1.0

www.opti-solar.com
1．Overlook
Ethernet port status LEDs:
100M LED (Green)
Flash
Port is operating at 100Mbit/s
Off
Card is not connected to the network
10M LED (Yellow)
Flash
Port is operating at 10Mbit/s
Off
Card is not connected to the network
2．Installation and Connection
Follow below steps to install and connect the SNMP manager:
Step 1: Remove the cover of intelligent slot on the back panel of UPS and
retain the screws
Step 2: Slide the card into the open slot and secure with the screws from
step 1. (see chart 2-1)
Chart 2-1
Refer to chart 2-2 for connecting the SNMP manager.
Ethernet port (10/100Base-T)
Sensor port
Golden finger: connects to UPS slot
Ethernet port status LEDs

www.opti-solar.com
Step 3: Plug Ethernet cable to the Ethernet port (RJ-45) on the SNMP
manager.
Step 4: Use one more Ethernet cable. Connect one end to the sensor port on
the SNMP manager and the other end to the optional environmental
monitoring device.
Chart 2-2
3．Configuration
a) Please install SolarPower Pro monitoring software in your PC. After
software is installed successfully, it will pop up a plug icon in
the tray. SNMP manager will be automatically activated.
Select “SNMP manager”by clicking right button of the mouse.
Chart 3-1

www.opti-solar.com
b) Enter specific IP address to search all SNMP devices in LAN. (The
SNMP manager will automatically collect the IP address from sever by
default via a DHCP server. It will apply default IP address of
192.168.102.230, default subnet mask as 255.255.255.0, and default
gateway as 0.0.0.0 without a DHCP server.
Chart 3-2
c) User can modify IP setting, online upgrade, password management,
and static trap address setting in SNMP Manager interface. It is
necessary to enter password for any medications. The default
password is 12345678.
Please check SNMP Manager User Manual for detailed configuration.

www.opti-solar.com
4. Monitoring
As chart 4-1, select “Open URL”by clicking right button of the mouse.
Chart 4-1
Then, it will activate SolarPower Pro software and list SNMP devices on the left
side of screen. Refer to Chart 4-2.
Chart 4-2
Please check SolarPower Pro software for detailed operation.