Outsider 202 Installation instructions manual

PLATEAU CITY CHAIR
#202 MOUNTING GUIDE
Kigkurren 8A Islands Brygge DK2300 Copenhagen · out-sider.dk

02
PLATEAU CITY CHAIR
Developed by out-sider in collaboration with Holscher Design 2021.
INDEX: PAGE
Item list ......................................................................................02
Fixation of armrest and side table............................................03
Surface mounting.......................................................................04
Cleaning and maintenance .....................................................05
Plateau City Chair
• No additional assembly required
Tools (not included)
• Allen key set
ITEM LIST
1x Chair
2x Armrest 1x Side table
ADD-ONS
Add-ons are not included with standard chair
4x Glider feet

03
FIXATION OF ARMREST AND SIDE TABLE
When mounting the armrest, unscrew the two rear bolts, and remove the two plastic spacers. Make sure to align the
armrest in parallel with the chair leg, before tightening the bolts.
It is the same procedure when mounting the side table. We recommend inding the desired angle of the chairs before
fastening the side table in place.
1 :
Step 2:
After placement fasten the M8 bolts.
Use grease to the bolts stick to the
allen key, for easier mounting.
Step 1:
Unscrew the M8 bolts and
remove the plastic spacers.
Plastic spacer
2x M8x12
2x M8x12
Armrest or side table
Arched cutout
For angle adjustment
ATTENTION:
- Only use provided bolts!
- Do not overtighten
2x 202 + side table
202 + 2x armrest

04
SURFACE MOUNTING OR GLIDER FEET
Use 4x bolts for surface mounting (not included). The chair is placed in the desired position on the surface.
Prepare the surface for ixation. Entry hole in the chair frame is Ø16 mm and exit hole Ø14. Be aware of
surface impurities and bumps before mounting. Alternatively, 4x rubber feat are inserted.
Bolt insertion Bolt insertion
Glider feet insertion
2 :
Surface mounting Glider feet

05
CLEANING AND MAINTENANCE
Clean the laminate surface with warm water and soft sponge.
NEVER use the abrasive “green” side of sponges. Use ordinary universal cleaner.
Diicult dirt must be removed with nanosponge and water. Take a closer look at
our website, or contact us for information.
Kigkurren 8A
Islands Brygge
DK2300 Copenhagen
out-sider.dk
[phone]