Outsider PLATEAU 205 Installation instructions manual

PLATEAU TABLE ROUND
#205 MOUNTING GUIDE
Kigkurren 8A Islands Brygge DK2300 Copenhagen · out-sider.dk

02
PLATEAU TABLE ROUND
Developed by out-sider in collaboration with Holscher Design 2021.
INDEX: PAGE
Item list ......................................................................................02
Fixation of legs onto center tube............................................03
Fixation of table onto center tube............................................04
Fixation of disc .........................................................................05
Cleaning and maintenance .....................................................06
ADD-ONS
Add-ons, not included with standard product
1x Point Sun
f. Picnic Round
Screws/bolts
• 4x M10x12 button head Hexagon socket
• 4x M10x20 cylinder Hexagon socket
• 1x M8x100 Hexagon socket
• 1x M8 nut
Tools (not included)
• Allen key set
• Socket wrench set
ITEM LIST
1x Table
4x Legs
1x Center tube 1x Disc

03
FIXATION OF LEGS ONTO CENTER TUBE
Place the center tube with the lange against the ground. Each leg is mounted with an M10x20 bolt from the inside of
the center tube. Tighten the bolts irmly.
1 :
Fastening of the leg.
The bolt is passed through the hole
from the inside. Use the Allen key
only when the bolt has gotten hold of
the thread.
4x M10x20

04
2 : FIXATION OF TABLE ONTO CENTER TUBE
After the seat has been itted, the table can be carefully laid on the center tube. The table comes with
a steel frame, ready for mounting on the center tube. All 4x M10x12 bolts are loosely screwed in and
retightened.
Placement of table
Carefully place the table on top of
the center tube.
Fastening of the table
Use M10x12 bolts to fasten the
tables to the center tube.
4x M10x12

05
3 : FIXATION OF DISC
Lastly, insert the disc and ixate it through the center tube. Use M8x100, washer and nut.
Insert the disc
The disc its in the milled surface.
Fastening of the disc
Use M8x100 bolt, nut and washer
to ixate.
M8x100 Washer M8 nut
ATTENTION:
- The disc will skewed if the
bolt is tightned too hard.

06
CLEANING AND MAINTENANCE
Clean the laminate surface with warm water and soft sponge.
NEVER use the abrasive “green” side of sponges. Use an ordinary universal cleaner.
Diicult dirt must be removed with a nano sponge and water. Take a closer look at
our website, or contact us for information.
Kigkurren 8A
Islands Brygge
DK2300 Copenhagen
out-sider.dk
[phone]