oventrop R-Tronic User manual

R-Tronic quick start guide
Pairing Thermostat and Operator
Turn the knob to show the MAINMENU
and push the knob to enter.
Turn the knob clockwise until the
display shows SETTINGS and
push the knob TWICE to enter
the TEACH function.
Push the knob once to start the
TEACH function. The TEACH
function will remain active for 30
seconds.
While the TEACH function is active,
push the LEARN button on the
operator once.
1
2
3
4
The operators MUST be within 2
feet of the thermostat for pairing
to be successful.
Repeat steps 3 through 5 for
each additional operator.
When the operator has been paired
with the thermostat the operator’s
LEDs will ash three times.
5
LEDs
Learn button
Mounting Operator to Valve
Thread the operator to the valve’s
actuator connection.
Push and hold the LEARN button
to start the operator’s calibration
cycle. Release button once motor
starts to move.
When the operator has nished
its calibration cycle the LEDs will
ash green three times.
1
2
3
Do not use tools to mount the
operator to the valve. Hand
tighten only.
Recalibration is not necessary
when the batteries are replaced.
When nished mounting the
operator to the valve, reattach the
operator cover.
4
If actuator blinks red,
recalibration is required.
Oventrop Corporation · Phone [phone] · www.oventrop-us.com

Basic Temperature Setting
Use knob for menu
navigation Use back button to
return to main screen
Turn the knob to show the MAINMENU
and push the knob to enter.
Turn the knob clockwise until the
display shows TEMPERATURE
and push the knob to enter.
Turn the knob clockwise until the display
shows COMFORT TEMPERATURE and
push the knob to enter.
1
2
3
4Turn the knob to increase or
decrease the value and push the
knob to conrm.
5Use AUTO/MANU button to select
the PROFILE ON / OFF
Setting to Fahrenheit
Turn the knob to show the MAINMENU
and push the knob to enter.
Turn the knob clockwise until the
display shows TEMPERATURE
and push the knob to enter.
Turn the knob clockwise until the display
shows TEMPERATURE UNIT and push
the knob to enter.
1
2
3
4Turn the knob to change from
Celsius to Fahrenheit and push the
knob to conrm.
R-Tronic quick start guide