Over Armour Offroad CA-MAVERICKX3-4-TC01 Installation manual

Over Armour Offroad
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Can-Am Maverick X3 (4Door)
Soft Top Cap
CA-MAVERICKX3-4-TC01
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab Material is Flammable.
1. Be sure to read these instructions thoroughly before opening and installing the Can Am
Maverick X3 (4 Door) Soft Door Kit. The installation is best done when the temperature
is 70 degrees F or warmer. The temperature affects the adhesive Velcro, if conditions
prevent installing in warmer weather, store the adhesive Velcro at room temperature prior
to installation.
2. Carefully open the carton and remove the enclosure on a large flat surface that is clean
and free of dirt.
3. Check the parts included in the carton with the parts list shown below:
Included Parts:
Soft Top Cap 1pc
2in Adhesive Backed Hook Velcro 4pcs x 3in Length
Webbing Straps with Velcro 4pcs
If any parts are damaged or missing, please contact customer service at [phone].
Note: Loosening or even removing a previously installed windshield will make installation
much easier.
Tools Needed for Installation:
No additional tools needed for installation.

Soft Top Cap Installation
1. Begin by laying the top cap on to the roof of the unit. Make sure the end with the longer
ears is oriented towards the front of the vehicle.
2. Place a piece of the adhesive backed Velcro around the roll cage on each of the 4 corners.
This Velcro will be used to secure the nylon webbing strips that secure the top cap to the
roll cage.
3. Attach one of the webbing strips around the previously installed adhesive Velcro strips.
Be sure the webbing strip is oriented towards the top cap.
4. Loosely connect each of the webbing strips to the ladder lock buckle on each of the 4
corners. Do not tighten at this time. The following images shows how the webbing
should be fed through the ladder lock buckle.

5. Once all for corners are started, begin by tightening each corner slightly. Work your way
around the vehicle tightening each corner but be sure to keep the edges of the top cap
aligned with the roll cage. Keep working your way around the vehicle until the top cap is
centered and secured tightly to the roll cage. When this is done the installation is
completed. The following images shows a completed top cap installation.

Cleaning and Storage Recommendations:
1. Before removing the Over Armour Cab for storage, make sure it is very clean in order to prevent
scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent
soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry
thoroughly before attempting to roll for storage.
2. It is important that the Cab be rolled up for storage rather than folding. Folding will cause
damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed
at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then,
interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll
approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a
normal room temperature. It is best not to expose the Cab to either extreme hot or cold
temperatures when storing.
3. A special cleaner conditioner is available from Over Armour that will greatly increase the service
life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also
be ordered.