Over Armour Offroad HO-700-WD05 Installation manual

Over Armour Offroad
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Honda Pioneer 700 and 700 4
Aero-Vent Polycarbonate Windshield
HO-700-WD05
NOTICE: Please check contents of package for any damage and make sure all parts fit
correctly and you are happy with the product before removing protective film. Once the
film is removed you cannot return the product for a full refund.
1. Be sure to read these instructions thoroughly before opening and installing the John
Honda Pioneer 700 and 700/4 Aero-Vent Polycarbonate Windshield.
2. Check over the parts included in the cartons with the parts list shown below:
1 5/8”Loom Clamps 8 each
1” Stainless Steels Bolts 13 each
Stainless Steel Washers 17 each
Plastic Thumb Nuts 9 each
Lock Nuts 4 each
Slide Fasteners 4 each
52” Rubber Gasket 1 each
Polycarbonate Brace 1 each
Polycarbonate Vent Slider 1 each
Polycarbonate Windshield 1 each
3. Start by pulling it out of the box and find a clean area to lay it down and install the
hardware. Begin by peeling off the protective film. Next take the 52” piece of rubber
gasket and starting at one end firmly place across the bottom of the windshield. You may
need to trim off excess gasket. The diagram below show where to install the gasket.
Diagram Not Pioneer 700

4. Next install the sliding vent panel on the inside of the windshield as shown in the diagram
below. To install slide fasteners push through holes with thumbs until it is completely
through the hole in the windshield and locked in place.
5. Now the Windshield is ready to be installed. With the help of a friend, place the
Windshield on the Pioneer, setting it up onto the hood.

6. Take the remaining hardware and install the windshield to the roll cage as shown in the
diagram below.
7. Now you can install the top brace if you want. If you do not have an Over Armour Cab
enclosure to work with this windshield, the top brace is not needed but can be installed
for extra strength. Below is a diagram showing how the brace is to be installed.

8. If you are using this windshield with an Over Armour Cab enclosure then you will use
the Top Brace to sandwich the cab material and seal off the inside from the wind. The
diagram below shows how it will work. If you aren’t using one of Over Armour's Cab
Enclosure you may opt not to use the Top Brace or install it for added strength.
9. Now you are ready to take it out and enjoy. To clean the windshield, always clean using
a liquid of some sort to decrease the chance of scratches. We recommend using micro
fiber cloths that are readily available at any dollar store. Any window cleaner will work
fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.

Return Policy
If for any reason you choose to return this product it must be returned within 30 days from date
item is received. You MUST package the product exactly as it was originally packaged from
the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes.
Lay all the windows on top of each other with the canvas folded in between and the paper (if
available) on both sides of the windows.
All returned products will be inspected upon arrival at the production facility and must be
in unused, factory new condition to receive refund - a 25% restocking fee will apply.
If ordered from Over Armour Offroad please call at 606-845-7439 to gain a return authorization
number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective,
you are responsible for paying the shipping to return the item.) Any returns submitted to Over
Armour Offroad without a return authorization number will be charged a 20% restocking
fee. If ordered from one of Over Armour Offroads many distributors’, you must first call them
and see what their return policy is. Once your item reaches our production facility, our customer
satisfaction team will inspect your item to ensure unused, factory new condition. NOTE: All
windshields must be returned with the original protective film intact and not removed. Do
NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a
windshield will only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect them during transit
and ensure your returned item arrives back factory fresh, and in new resalable condition (any
returned items that have been used, altered or damaged in any way will not be subject for a
refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will be approved.
Once returned items are received, credit will be issued to the original credit card/ payment
method used for the purchase. Outbound shipping and return shipping cost will not be refunded.
Please allow 4 to 6 weeks for your refund to be processed.

Warranty
To The Owner of this Product:
Thank you for purchasing one of Over Armour Offroad Cab Enclosures, Tops &/or Windshields!
Below are the terms under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or
windshield due to defect of the product. Please refer to the return policy in this case for more
information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will
gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for
the correction or replacement we will need to receive pictures of the defect in material or
workmanship along with the receipt from the date of purchase.
Thank you,
Over Armour Offroad
www.overarmouroffroad.com