Oxford Garden CDCHK User manual

15 Kingbrook Parkway, Suite 100
Simpsonville, KY 40067
p. 877.866.3331 f. 502.719.8888
oxfordgarden.com
CLASSIC ARMCHAIR - CDCHK
ASSEMBLY
INSTRUCTIONS
Ver. 2019.06.03
COMPONENTS HARDWARE
1
3
Right Arm Assembly
Quantity: 1
Back
Quantity: 1
2
Left Arm Assembly
Quantity: 1
B
4
Seat
Quantity: 1
Dowels
Quantity: 14
A
Wood Screws
Quantity: 6
B
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: If the furniture is going to be placed on a concrete
or tile patio, it should first be rinsed well to remove the
sawdust that may cause some staining.
5
Front Rail
Quantity: 1
A hammer and a phillips head screwdriver (not provided)
will be needed for the assembly of this bench.
NOTE: Hardware pack may contain more hardware than
what is needed to assemble.

STEP 4
With a hammer, drive 4 dowels into the predrilled holes
found on the front of the leg assemblies to hold the front
rail into place. Drive the remaining 8 dowels into the
predrilled holes located on the back of the leg assemblies
to hold the back in place. Insert the tapered end of the
dowels first.
STEP 2
Locate the small label on the bottom of the seat that reads
“front”. With the front of the seat toward the front of the
bench, line up and insert the front rail and seat into the
right leg assembly.
INSTRUCTIONS
STEP 1
On a clean flat surface, lay right leg assembly on its side
mortise holes facing up. Place the back into the mortise
of the right leg assembly.
Ver. 2019.06.03

3
4
STEP 3
Line up and place left leg assembly onto those parts
already assembled.
STEP 5
Using a phillips head screwdriver, screw the 4 total wood
screws into the predrilled holes on the underside of the
seat to attach the seat to the arm assemblies as shown.
STEP 6
Enjoy your new chair!
2
5
3
A

5
4
2
3
5
A
A
A
AA
A
5
3
2
5
B
B
B